- 25 4月, 2017 4 次提交
-
-
由 Hou Zhiqiang 提交于
The PPA is a EL3 firmware, which support PSCI, hotplug, power-management features etc. Signed-off-by: NHou Zhiqiang <Zhiqiang.Hou@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 Hou Zhiqiang 提交于
Signed-off-by: NHou Zhiqiang <Zhiqiang.Hou@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 Hou Zhiqiang 提交于
The PPA is a EL3 firmware, which support PSCI, hotplug, power-management features etc. Signed-off-by: NHou Zhiqiang <Zhiqiang.Hou@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 Santan Kumar 提交于
Signed-off-by: NSantan Kumar <santan.kumar@nxp.com> Signed-off-by: NPriyanka Jain <priyanka.jain@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
- 24 4月, 2017 1 次提交
-
-
由 Alison Wang 提交于
Since commit ce412b79, RGMII TX clock internal delay is not enabled for AR8033 unconditionally. On LS1021ATWR board, the third port eTSEC3 uses AR8033 in RGMII mode. The TX/RX internal delay needs to be enabled. This patch will set PHY_INTERFACE_MODE_RGMII_ID to enable RGMII TX/RX clock internal delay for AR8033 on the third port. Signed-off-by: NAlison Wang <alison.wang@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
- 18 4月, 2017 35 次提交
-
-
-
-
-
由 Tom Rini 提交于
Since 936478e7 SPARC as been removed as an architecture. Remove these now orphan boards. Signed-off-by: NTom Rini <trini@konsulko.com>
-
由 Simon Glass 提交于
At present if the return to bootrom fails (e.g. because you are not using the Rockchip's bootrom's pointer table in MMC) then the board prints SPL message and hangs. Print a message first if we can, to help in understanding what happened when it hangs. Signed-off-by: NSimon Glass <sjg@chromium.org> Tested-by: NHeiko Stuebner <heiko@sntech.de> Acked-by: NHeiko Stuebner <heiko@sntech.de>
-
由 xypron.glpk@gmx.de 提交于
'A || (!A && B)' is equivalent to 'A || B'. Let's reduce the complexity of the statement in start_jr0(). The problem was indicated by cppcheck. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NYork Sun <york.sun@nxp.com> Reviewed-by: NSimon Glass <sjg@chromium.org>
-
由 xypron.glpk@gmx.de 提交于
After allocating sata->cmd_hdr_tbl_offset we have to check this variable and not variable sata. The problem was indicated by cppcheck. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com>
-
由 xypron.glpk@gmx.de 提交于
(pdimm[0].data_width >= 32) || (pdimm[0].data_width <= 40) is always true. We should use && here. The problem was indicated by cppcheck. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 xypron.glpk@gmx.de 提交于
The number of arguments for printf does not match the format string. The problem was indicated by cppcheck. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com>
-
由 xypron.glpk@gmx.de 提交于
If current_urb is NULL it should not be dereferenced. The problem was indicated by cppcheck. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com>
-
由 xypron.glpk@gmx.de 提交于
If !parent, the changed line is not reached. So there is no need to check the value again. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com>
-
由 xypron.glpk@gmx.de 提交于
If realloc fails we should release the old buffer. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com> Reviewed-by: NSimon Glass <sjg@chromium.org>
-
由 xypron.glpk@gmx.de 提交于
Each call of va_start must be matched by a call of va_end. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com>
-
由 Tom Rini 提交于
Linaro provides a number of pre-built GCC toolchains for both 32 and 64bit ARM. Switch to their 2017.02 release of gcc-6.3.1 for both. Cc: Koen Kooi <koen.kooi@linaro.org> Signed-off-by: NTom Rini <trini@konsulko.com>
-
由 Tom Rini 提交于
Many toolchains for ARM use the 'gnueabihf' suffix rather than just 'gnueabi', so allow these to be used, but with a lower priority than 'gnueabi' ones. Cc: Simon Glass <sjg@chromium.org> Signed-off-by: NTom Rini <trini@konsulko.com> Reviewed-by: NSimon Glass <sjg@chromium.org>
-
由 Masahiro Yamada 提交于
If the system is running PSCI firmware, the System Reset function (func ID: 0x80000009) is supposed to be handled by PSCI, that is, the SoC/board specific reset implementation should be moved to PSCI. U-Boot should call the PSCI service according to the arm-smccc manner. The arm-smccc is supported on ARMv7 or later. Especially, ARMv8 generation SoCs are likely to run ARM Trusted Firmware BL31. In this case, U-Boot is a non-secure world boot loader, so it should not be able to reset the system directly. Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>
-
由 Masahiro Yamada 提交于
Adjust ARM SMC Calling Convention code for U-Boot: - Replace the license block with SPDX - Change path to asm-offsets.h - Define UNWIND() as no-op - Add Kconfig entry - Add asm-offsets Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>
-
由 Masahiro Yamada 提交于
Imports ARM SMC Calling Convention code from Linux 4.11-rc6. The files have been copied as follows: [Linux] [U-Boot] arch/arm/kernel/smccc-call.S -> arch/arm/cpu/armv7/smccc-call.S arch/arm64/kernel/smccc-call.S -> arch/arm/cpu/armv8/smccc-call.S arch/arm/include/asm/opcodes* -> arch/arm/include/asm/opcodes* include/linux/arm-smccc.h -> include/linux/arm-smccc.h Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>
-
由 Masahiro Yamada 提交于
This is a Blackfin board that commit ea3310e8 ("Blackfin: Remove") missed to remove. Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>
-
由 Masahiro Yamada 提交于
These drivers have no user since commit ea3310e8 ("Blackfin: Remove"). Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com> Reviewed-by: NSimon Glass <sjg@chromium.org> Acked-by: NMichal Simek <michal.simek@xilinx.com> Acked-by: NJaehoon Chung <jh80.chung@samsung.com>
-
由 Masahiro Yamada 提交于
These commands have no user since commit ea3310e8 ("Blackfin: Remove"). Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com> Reviewed-by: NSimon Glass <sjg@chromium.org>
-
由 Masahiro Yamada 提交于
Recently, U-Boot removed support for these architectures. Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>
-
由 Tyler Hall 提交于
Handle symlinks to files in the current directory. Other cases could be handled with additional code, but this is a start. Add explicit errors for absolute paths and links found in the middle of a path (directories). Other cases like '..' or '.' will result with the file not being found as when those path components are explicitly provided. Add a helper to decompress a null-terminated link name which is shared with cramfs_list_inode. Signed-off-by: NTyler Hall <tylerwhall@gmail.com>
-
由 Tyler Hall 提交于
Using a variably-sized type is incorrect here since we're reading a fixed file format. Fixes cramfs on 64-bit platforms. Signed-off-by: NTyler Hall <tylerwhall@gmail.com>
-
由 Tyler Hall 提交于
As with most other commands, this needs to factor in the sysmem offset in the sandbox or it will try to dereference the simulated physical address directly. Signed-off-by: NTyler Hall <tylerwhall@gmail.com>
-
由 Simon Glass 提交于
Enable this command so we can get an approximate performance measurement. Signed-off-by: NSimon Glass <sjg@chromium.org> Reviewed-by: NBin Meng <bmeng.cn@gmail.com>
-
由 Simon Glass 提交于
At present on a cold reboot we must reset the CPU to get it to full speed. With 64-bit U-Boot this happens in SPL. At present we print the banner before doing this, the end result being that we print the banner twice. Print the banner a little later (after the CPU is ready) to avoid this. Signed-off-by: NSimon Glass <sjg@chromium.org> Reviewed-by: NBin Meng <bmeng.cn@gmail.com> Tested-by: NBin Meng <bmeng.cn@gmail.com>
-
由 Simon Glass 提交于
The Intel CPU name can have leading spaces. Remove them since they are not useful. Signed-off-by: NSimon Glass <sjg@chromium.org> Reviewed-by: NBin Meng <bmeng.cn@gmail.com>
-
由 xypron.glpk@gmx.de 提交于
A size_t variable can never be negative. The problem was indicated by cppcheck. Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de> Reviewed-by: NTom Rini <trini@konsulko.com> Reviewed-by: NHeiko Schocher <hs@denx.de>
-
由 Tom Rini 提交于
Signed-off-by: NTom Rini <trini@konsulko.com>
-
由 Shengzhou Liu 提交于
As board-specific reset logic, it needs to issue reset signal via CPLD when issuing 'reset' command in u-boot, this patch solves the issue of reset command not working on T1024RDB. Signed-off-by: NShengzhou Liu <Shengzhou.Liu@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 Ruchika Gupta 提交于
For E6500 cores, L2 cache has been used as init_ram. L1 cache is a write through cache on E6500.If lines are not locked in both L1 and L2 caches, crashes are observed during secure boot. This patch locks/ unlocks both L1 and L2 cache to prevent the crash. Signed-off-by: NRuchika Gupta <ruchika.gupta@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 Yangbo Lu 提交于
Current sysclk fixing would fix all clocks with 'fixed-clock' compatible. This patch is to fix sysclk by path to avoid any incorrect fixing. Signed-off-by: NYangbo Lu <yangbo.lu@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 Ashish kumar 提交于
Number of TZASC instances may vary across NXP SoCs. So put TZASC configuration under instance specific defines. Signed-off-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com> Signed-off-by: NAshish Kumar <Ashish.Kumar@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-
由 Santan Kumar 提交于
Signed-off-by: NSantan Kumar <santan.kumar@nxp.com> Signed-off-by: NPriyanka Jain <priyanka.jain@nxp.com> Reviewed-by: NYork Sun <york.sun@nxp.com>
-