This is a preparation patch for switching all sunxi boards over to using
the driver model.

Note that rather then defining both CONFIG_DEFAULT_DEVICE_TREE (for u-boot)
and CONFIG_FDTFILE (for the kernel), this commit simply replaces all
CONFIG_FDTFILE defconfig settings with CONFIG_DEFAULT_DEVICE_TREE and
uses CONFIG_DEFAULT_DEVICE_TREE for setting the default fdtfile env value
in sunxi-common.h .
Signed-off-by: NHans de Goede <hdegoede@redhat.com>
Reviewed-by: NSimon Glass <sjg@chromium.org>
Acked-by: NIan Campbell <ijc@hellion.org.uk>

Move this to Kconfig and clean up board config files that use it. Also
rename it to CONFIG_ETH_DESIGNWARE to fit with the naming that exists
in drivers/net/Kconfig.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Version 1:
Acked-by: NJoe Hershberger <joe.hershberger@ni.com>

Since commit e02ee254 (kconfig: switch to single .config
configuration), the prefixes in defconfig files such as "+S:",
"+ST:", etc., are meaningless.

This commit was generated by the following command:

  find configs -name '*_defconfig' | xargs sed -i 's/^+*S*T*://'
Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>

This is a low-cost Allwinner A20 board with Arduino-style GPIO headers;
it features 1G RAM, 4G NAND flash, 1 micro-SD, 2 USB sockets, 1 micro
USB socket for OTG and another for power in, HDMI, SATA, 5V power for
SATA devices, gigabit Ethernet, an IR receiver, 3.5mm audio out and a
MIPI camera connector.

Like the BananaPi, this board needs GMAC_TX_DELAY set to 3 in order for
GMAC to work reliably at gigabit speeds.

For more details, see: http://linux-sunxi.org/LinkSprite_pcDuino3_NanoSigned-off-by: NAdam Sampson <ats@offog.org>
Acked-by: NHans de Goede <hdegoede@redhat.com>
Signed-off-by: NHans de Goede <hdegoede@redhat.com>