Signed-off-by: NAlbert ARIBAUD <albert.u.boot@aribaud.net>
Acked-by: NStefan Roese <sr@denx.de>

* 'master' of git://git.denx.de/u-boot-arm:
  OMAP3: beagle: Fix build warning in beagle.c

This is a trivial fix in the documentation, which corrects
board_init_r() source reference.
Signed-off-by: NVladimir Zapolskiy <vz@mleia.com>
Acked-by: NMike Frysinger <vapier@gentoo.org>

Fix build warning

beagle.c:532: warning: initialization from incompatible pointer type
Signed-off-by: NDirk Behme <dirk.behme@googlemail.com>
CC: Jason Kridner <jkridner@beagleboard.org>
CC: Koen Kooi <koen@dominion.thruhere.net>
CC: Joel A Fernandes <agnel.joel@gmail.com>
Cc: Greg Turner <gregturner@ti.com>
CC: Sandeep Paulraj <s-paulraj@ti.com>
Acked-by: NJason Kridner <jkridner@beagleboard.org>

Signed-off-by: NWolfgang Denk <wd@denx.de>

Signed-off-by: NWolfgang Denk <wd@denx.de>

The MAC address stored in the inventory eeprom begins at offset 1.
Signed-off-by: NHolger Brunck <holger.brunck@keymile.com>
Signed-off-by: NValentin Longchamp <valentin.longchamp@keymile.com>
cc: Wolfgang Denk <wd@denx.de>

On some systems, we get a warning when %lu is used with size_t's, so
use the correct format string.
Signed-off-by: NVadim Bendebury <vbendeb@chromium.org>
Signed-off-by: NMike Frysinger <vapier@gentoo.org>

The new sanity check introduces a printf warning for some systems:
	eth.c:233: warning: format '%zu' expects type 'size_t', but argument 3 has type 'int'

Rather than tweak the format string, use the new assert() helper instead.
Signed-off-by: NMike Frysinger <vapier@gentoo.org>

Recent commit a4814a69 cleaned up generation of
asm-offsets.s for SoC dirs, but missed adding it to the ignore
list which makes it show up in `git status`.
Signed-off-by: NMike Frysinger <vapier@gentoo.org>

There is no code anywhere that references BOOTFLAG_* so remove these
defines.
Signed-off-by: NWolfgang Denk <wd@denx.de>
Cc: Heiko Schocher <hs@denx.de>
Cc: Valentin Longchamp <valentin.longchamp@keymile.com>
Cc: Peter Tyser <ptyser@xes-inc.com>

Commit 09349866 (Put common autoload code into auto_load() function)
broke handling of autoload environment variable not being set.
The bootp/dhcp code will just keep on requesting IP address forever
and never start TFTP download.

Fix it by moving TftpStart() outside the conditional like it was before.
Signed-off-by: NPeter Korsgaard <jacmet@sunsite.dk>
Tested-by: NFabio Estevam <fabio.estevam@freescale.com>
Acked-by: NSimon Glass <sjg@chromium.org>

Flush the dcache before removing the TLB with caches enabled.
Otherwise this might lead to problems later on, e.g. while booting
Linux (as seen on ICON-440SPe).
Signed-off-by: NStefan Roese <sr@denx.de>

Change bd_t->bi_phy* arrays from 1 to 2 for PPC405EX since
405EX has 2 ethernet interfaces.
Signed-off-by: NBernhard Weirich <bernhard.weirich@riedel.net>
Signed-off-by: NStefan Roese <sr@denx.de>

This commit fixes a build warning in the DA830 EVM build
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Result of running the following command to address Wolfgang's
comment about camel case:

for file in `find . | grep '\.[chS]$'`; do perl -i -pe
's/(green|yellow|red|blue)_LED_(on|off)/$1_led_$2/g' $file; done

Discussion:
http://patchwork.ozlabs.org/patch/84988/Signed-off-by: NJason Kridner <jkridner@beagleboard.org>
Signed-off-by: NJoel A Fernandes <agnel.joel@gmail.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

omap4: fix pad configuration settings for SDP and Panda
Signed-off-by: NAneesh V <aneesh@ti.com>
Signed-off-by: NSebastien Jan <s-jan@ti.com>
Signed-off-by: NDavid Anders <x0132446@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Tuning some IO settings for better performance and power.
And consolidate all such IO settings at one place.
Signed-off-by: NAneesh V <aneesh@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

SDRAM init was not working on ES1.0 due to a programming
error. A pointer that was passed by value to a function
was set in function emif_get_device_details(), but the effect
wouldn't be seen in the calling function. The issue came
out while testing for ES1.0 because ES1.0 doesn't have any
SDRAM chips connected to CS1
Signed-off-by: NAneesh V <aneesh@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Factor out common parts from omap4_sdp4430.h and omap4_panda.h
into a new file omap4_common.h
Signed-off-by: NAneesh V <aneesh@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

This patch contains updates the sources in the board files
to use the generic API.
Signed-off-by: NSanjeev Premi <premi@ti.com>

This patch contains the generic changes required after
change to generic API in the previous patch.
Signed-off-by: NSanjeev Premi <premi@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Convert all OMAP specific functions to use the common API
definitions in include/asm/gpio.h. In the process, made
few additional changes:
 - Use -EINVAL consistently. -1 was used in many places.
 - Removed one-liner static functions that were used only
   once. Replaced the content as necessary.
 - Combines implementation of functions omap_get_gpio_dataout()
   and omap_get_gpio_datain(). To do so, new static function
   _get_gpio_direction() was added.
Signed-off-by: NSanjeev Premi <premi@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

This patch removes a hardcoded MAC address
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Modify the MEMTEST start and end address. The memtest range was overlapping the
CONFIG_SYS_LOAD_ADDR which causes the uImage to be corrupt.Also, modify the
size for which mtest is run to 32MB from 16MB.
Signed-off-by: NSudhakar Rajashekhara <sudhakar.raj@ti.com>
Signed-off-by: NNagabhushana Netagunte <nagabhushana.netagunte@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Enable SPI flash boot mode in configuration file as default.
With the introduction of 456MHz part, SPI operating frequency
will increase and at this frequency SPI does not work correctly.
Hence reduce the default SPI speed to 30MHz from 50MHz.
Signed-off-by: NSudhakar Rajashekhara <sudhakar.raj@ti.com>
Signed-off-by: NNagabhushana Netagunte <nagabhushana.netagunte@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Modify U-boot promt string from 'DA830-evm >' to 'U-Boot >' as
there are many variants of da830 based boards which have diffrent
names such as L137, AM1707 etc.
Signed-off-by: NSudhakar Rajashekhara <sudhakar.raj@ti.com>
Signed-off-by: NNagabhushana Netagunte <nagabhushana.netagunte@ti.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

OMAP3: Add 37xx ESx revision numbers.
Signed-off-by: NMichael Jones <michael.jones@matrix-vision.de>
Signed-off-by: NHoward D. Gray <howard.gray@matrix-vision.de>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Signed-off-by: NMichael Jones <michael.jones@matrix-vision.de>
Acked-by: NHeiko Schocher <hs@denx.de>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

This allows the EEPROM layer to send a single i2c write command
per page, and wait CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS between
i2c write commands.
Signed-off-by: NMichael Jones <michael.jones@matrix-vision.de>
Acked-by: NHeiko Schocher <hs@denx.de>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Read directly from OMAP_GPIO_DATAOUT to get the output state of the GPIO pin
Signed-off-by: NJoel A Fernandes <agnel.joel@gmail.com>
Signed-off-by: NJason Kridner <jkridner@beagleboard.org>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

Cleanup tx25.h by removing unnecessary defines and by removing unneeded "1"'s.
Signed-off-by: NFabio Estevam <fabio.estevam@freescale.com>

Make use of GPIO framework and avoid the following build error:

tx25.c: In function 'tx25_fec_init':
tx25.c:73: error: dereferencing pointer to incomplete type
tx25.c:74: error: dereferencing pointer to incomplete type
tx25.c:75: error: dereferencing pointer to incomplete type
tx25.c:76: error: dereferencing pointer to incomplete type
tx25.c:83: error: dereferencing pointer to incomplete type
tx25.c:84: error: dereferencing pointer to incomplete type
tx25.c:114: error: dereferencing pointer to incomplete type
tx25.c:115: error: dereferencing pointer to incomplete type
tx25.c:116: error: dereferencing pointer to incomplete type
tx25.c:117: error: dereferencing pointer to incomplete type
tx25.c:124: error: dereferencing pointer to incomplete type
tx25.c:125: error: dereferencing pointer to incomplete type
tx25.c:126: error: dereferencing pointer to incomplete type
Signed-off-by: NFabio Estevam <fabio.estevam@freescale.com>
Acked-by: NStefano Babic <sbabic@denx.de>

This patch fixes the warning dure to recent changes to the board
configuration:
cmd_i2c.o cmd_i2c.c -c
cmd_i2c.c:109:1: warning: missing braces around initializer
cmd_i2c.c:109:1: warning: (near initialization for 'i2c_no_probes[0]')
Signed-off-by: NSanjeev Premi <premi@ti.com>
Cc: Jason Kridner <jkridner@beagleboard.org>
Acked-by: NJason Kridner <jdk@ti.com>

Signed-off-by: NWolfgang Denk <wd@denx.de>

Signed-off-by: NWolfgang Denk <wd@denx.de>

Fix build problem:

nand_spl/board/davinci/da8xxevm/hawkboard_nand_spl.c: In function 'board_init_f':
nand_spl/board/davinci/da8xxevm/hawkboard_nand_spl.c:132: warning: implicit declaration of function 'nand_boot'
nand_spl/board/davinci/da8xxevm/hawkboard_nand_spl.c:133: warning: 'noreturn' function does return
Signed-off-by: NWolfgang Denk <wd@denx.de>
Cc: Syed Mohammed Khasim <sm.khasim@gmail.com>
Cc: Sughosh Ganu <urwithsughosh@gmail.com>
Cc: Albert ARIBAUD <albert.u.boot@aribaud.net>

Fix these:
cm4008.c: In function 'board_eth_init':
cm4008.c:79: warning: implicit declaration of function 'ks8695_eth_initialize'

cm41xx.c: In function 'board_eth_init':
cm41xx.c:79: warning: implicit declaration of function 'ks8695_eth_initialize'

While we are at it, sort include list in netdev.h
Signed-off-by: NWolfgang Denk <wd@denx.de>
Cc: Greg Ungerer <greg.ungerer@opengear.com>

Commit 21726a7a "Add assert() for debug assertions" caused build
warnings for all tegra2 based boards:

clock.c:36:1: warning: "assert" redefined
In file included from clock.c:29:
include/common.h:144:1: warning: this is the location of the previous definition
Signed-off-by: NWolfgang Denk <wd@denx.de>
Cc: Simon Glass <sjg@chromium.org>

get_ram_size() is called, but memsize.c is not compiled.
Signed-off-by: NStefano Babic <sbabic@denx.de>