The MDIO controller to talk to external PHYs is on FM1-DTSEC1 so don't
allow disabling.  If we disable it we end up powering the block down in
the SoC and thus can't communicate to any external PHYs.
Signed-off-by: NKumar Gala <galak@kernel.crashing.org>

The SoC configuration may have more ports enabled than a given board
actually can utilize.  Add a routinue that allows the board code to
disable a port that it knows isn't being used.

fm_disable_port() needs to be called before cpu_eth_init().
Signed-off-by: NKumar Gala <galak@kernel.crashing.org>

The Frame Manager (FMan) on QorIQ SoCs with DPAA (datapath acceleration
architecture) is the ethernet contoller block.  Normally it is utilized
via Queue Manager (Qman) and Buffer Manager (Bman).  However for boot
usage the FMan supports a mode similar to QE or CPM ethernet collers
called Independent mode.

Additionally the FMan block supports multiple 1g and 10g interfaces as a
single entity in the system rather than each controller being managed
uniquely.  This means we have to initialize all of Fman regardless of
the number of interfaces we utilize.

Different SoCs support different combinations of the number of FMan as
well as the number of 1g & 10g interfaces support per Fman.

We add support for the following SoCs:
 * P1023 - 1 Fman, 2x1g
 * P4080 - 2 Fman, each Fman has 4x1g and 1x10g
 * P204x/P3041/P5020 - 1 Fman, 5x1g, 1x10g
Signed-off-by: NDave Liu <daveliu@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>
Signed-off-by: NTimur Tabi <timur@freescale.com>
Signed-off-by: NRoy Zang <tie-fei.zang@freescale.com>
Signed-off-by: NDai Haruki <dai.haruki@freescale.com>
Signed-off-by: NKim Phillips <kim.phillips@freescale.com>
Signed-off-by: NIoana Radulescu <ruxandra.radulescu@freescale.com>
Signed-off-by: NLei Xu <B33228@freescale.com>
Signed-off-by: NMingkai Hu <Mingkai.hu@freescale.com>
Signed-off-by: NScott Wood <scottwood@freescale.com>
Signed-off-by: NShaohui Xie <b21989@freescale.com>
Signed-off-by: NKumar Gala <galak@kernel.crashing.org>