- 06 9月, 2009 1 次提交
-
-
由 Eric Millbrandt 提交于
Reset any i2c devices that may have been interrupted during a system reset. Normally this would be accomplished by clocking the line until SCL and SDA are released and then sending a start condtiion (From an Atmel datasheet). There is no direct access to the i2c pins so instead create start commands through the i2c interface. Send a start command then delay for the SDA Hold time, repeat this by disabling/enabling the bus a total of 9 times. Signed-off-by: NEric Millbrandt <emillbrandt@dekaresearch.com>
-
- 05 9月, 2009 1 次提交
-
-
由 Eric Millbrandt 提交于
Signed-off-by: NEric Millbrandt <emillbrandt@dekaresearch.com>
-
- 27 8月, 2009 1 次提交
-
-
由 Eric Millbrandt 提交于
Signed-off-by: NEric Millbrandt <emillbrandt@dekaresearch.com>
-
- 25 8月, 2009 1 次提交
-
-
由 Eric Millbrandt 提交于
Add support for the DEKA Research and Development galaxy5200 board The galaxy5200 is an Freescale mpc5200 based embedded industrial control board. Signed-off-by: NEric Millbrandt <emillbrandt@dekaresearch.com>
-