提交 f12341a9 编写于 作者: J Jagan Teki 提交者: Peng Fan

mmc: sdhci: Fix HISPD bit handling

SDHCI HISPD bits need to be configured based on desired mmc
timings mode and some HISPD quirks.

So, handle the HISPD bit based on the mmc computed selected
mode(timing parameter) rather than fixed mmc card clock
frequency.

Linux handle the HISPD similar like this in below commit but no
SDHCI_QUIRK_BROKEN_HISPD_MODE,

commit <501639bf2173> ("mmc: sdhci: fix SDHCI_QUIRK_NO_HISPD_BIT handling")

This eventually fixed the mmc write issue observed in
rk3399 sdhci controller.

Bug log for refernece,
=> gpt write mmc 0 $partitions
Writing GPT: mmc write failed
** Can't write to device 0 **
** Can't write to device 0 **
error!

Cc: Kever Yang <kever.yang@rock-chips.com>
Cc: Peng Fan <peng.fan@nxp.com>
Peng Fan: added back "ctrl &= ~SDHCI_CTRL_HISPD;" per Jaehoon's suggestion
Tested-by: Suniel Mahesh <sunil@amarulasolutions.com> # roc-rk3399-pc
Signed-off-by: NJagan Teki <jagan@amarulasolutions.com>
上级 fe95905f
......@@ -567,6 +567,7 @@ static int sdhci_set_ios(struct mmc *mmc)
#endif
u32 ctrl;
struct sdhci_host *host = mmc->priv;
bool no_hispd_bit = false;
if (host->ops && host->ops->set_control_reg)
host->ops->set_control_reg(host);
......@@ -594,14 +595,26 @@ static int sdhci_set_ios(struct mmc *mmc)
ctrl &= ~SDHCI_CTRL_4BITBUS;
}
if (mmc->clock > 26000000)
ctrl |= SDHCI_CTRL_HISPD;
else
ctrl &= ~SDHCI_CTRL_HISPD;
if ((host->quirks & SDHCI_QUIRK_NO_HISPD_BIT) ||
(host->quirks & SDHCI_QUIRK_BROKEN_HISPD_MODE))
(host->quirks & SDHCI_QUIRK_BROKEN_HISPD_MODE)) {
ctrl &= ~SDHCI_CTRL_HISPD;
no_hispd_bit = true;
}
if (!no_hispd_bit) {
if (mmc->selected_mode == MMC_HS ||
mmc->selected_mode == SD_HS ||
mmc->selected_mode == MMC_DDR_52 ||
mmc->selected_mode == MMC_HS_200 ||
mmc->selected_mode == MMC_HS_400 ||
mmc->selected_mode == UHS_SDR25 ||
mmc->selected_mode == UHS_SDR50 ||
mmc->selected_mode == UHS_SDR104 ||
mmc->selected_mode == UHS_DDR50)
ctrl |= SDHCI_CTRL_HISPD;
else
ctrl &= ~SDHCI_CTRL_HISPD;
}
sdhci_writeb(host, ctrl, SDHCI_HOST_CONTROL);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册