ARM: Document AArch64 version of qemu-arm

It's mostly obvious, except that QEMU is annoying and requires an
explicit '-cpu cortex-a57' (or some other 64-bit core) to actually run
in 64-bit mode.

While at it, remove the references to setting the ARCH environment
variable; that is not used in U-Boot.
Signed-off-by: NTuomas Tynkkynen <tuomas.tynkkynen@iki.fi>
Reviewed-by: NTom Rini <trini@konsulko.com>

doc/README.qemu-arm

@@ -4,11 +4,12 @@
 # SPDX-License-Identifier:	GPL-2.0+
 #
 
-U-Boot on QEMU's 'virt' machine on ARM
-======================================
+U-Boot on QEMU's 'virt' machine on ARM & AArch64
+================================================
 
 QEMU for ARM supports a special 'virt' machine designed for emulation and
 virtualization purposes. This document describes how to run U-Boot under it.
+Both 32-bit ARM and AArch64 are supported.
 
 The 'virt' platform provides the following as the basic functionality:
 
@@ -17,7 +18,7 @@ The 'virt' platform provides the following as the basic functionality:
     - A generated device tree blob placed at the start of RAM
     - A freely configurable amount of RAM, described by the DTB
     - A PL011 serial port, discoverable via the DTB
-    - An ARMv7 architected timer
+    - An ARMv7/ARMv8 architected timer
     - PSCI for rebooting the system
     - A generic ECAM-based PCI host controller, discoverable via the DTB
 
@@ -25,19 +26,29 @@ Additionally, a number of optional peripherals can be added to the PCI bus.
 
 Building U-Boot
 ---------------
-Set the CROSS_COMPILE and ARCH=arm environment variables as usual, and run:
+Set the CROSS_COMPILE environment variable as usual, and run:
 
+- For ARM:
     make qemu_arm_defconfig
     make
 
+- For AArch64:
+    make qemu_arm64_defconfig
+    make
+
 Running U-Boot
 --------------
 The minimal QEMU command line to get U-Boot up and running is:
 
+- For ARM:
     qemu-system-arm -machine virt,highmem=off -bios u-boot.bin
 
+- For AArch64:
+    qemu-system-aarch64 -machine virt,highmem=off -cpu cortex-a57 -bios u-boot.bin
+
 The 'highmem=off' parameter to the 'virt' machine is required for PCI to work
-in U-Boot.
+in U-Boot. Also, for some odd reason qemu-system-aarch64 needs to be explicitly
+told to use a 64-bit CPU or it will boot in 32-bit mode.
 
 Additional peripherals that have been tested to work in both U-Boot and Linux
 can be enabled with the following command line parameters: