armv8: ls1012a: RGMII ports require internal delay

The correct setting for the RGMII ports on LS1012ARDB is to
enable delay on both Rx and Tx so the interface mode used should
be PHY_INTERFACE_MODE_RGMII_ID
Signed-off-by: NChaitanya Sakinam <chaitanya.sakinam@nxp.com>
Signed-off-by: NAnji J <anji.jagarlmudi@nxp.com>
Reviewed-by: NPriyanka Jain <priyanka.jain@nxp.com>

board/freescale/ls1012ardb/eth.c

@@ -113,7 +113,7 @@ int pfe_eth_board_init(struct udevice *dev)
 			/* MAC2 */
 			pfe_set_phy_address_mode(priv->gemac_port,
 						 CONFIG_PFE_EMAC2_PHY_ADDR,
-						 PHY_INTERFACE_MODE_RGMII_TXID);
+						 PHY_INTERFACE_MODE_RGMII_ID);
 		}
 		break;
 	case 0x2208:

drivers/net/pfe_eth/pfe_eth.c

@@ -33,7 +33,7 @@ struct gemac_s gem_info[] = {
 
 		/* phy iface */
 		.phy_address = CONFIG_PFE_EMAC2_PHY_ADDR,
-		.phy_mode = PHY_INTERFACE_MODE_RGMII_TXID,
+		.phy_mode = PHY_INTERFACE_MODE_RGMII_ID,
 	},
 };