ARM: mx6: ddr: use Kconfig for inclusion of DDR calibration routines

The DDR calibration routines are gated by conditionals for the
i.MX6DQ SOCs, but with the use of the sysinfo parameter, these
are usable on at least i.MX6SDL and i.MX6SL variants with DDR3.

Also, since only the Novena board currently uses the dynamic
DDR calibration routines, these routines waste space on other
boards using SPL.

Add a KConfig entry to allow boards to selectively include the
DDR calibration routines.
Signed-off-by: NEric Nelson <eric@nelint.com>

arch/arm/cpu/armv7/mx6/Kconfig

@@ -35,6 +35,14 @@ config MX6ULL
 	bool
 	select MX6UL
 
+config MX6_DDRCAL
+	bool "Include dynamic DDR calibration routines"
+	depends on SPL
+	default n
+	help
+	  Say "Y" if your board uses dynamic (per-boot) DDR calibration.
+	  If unsure, say N.
+
 choice
 	prompt "MX6 board select"
 	optional

arch/arm/cpu/armv7/mx6/ddr.c

@@ -14,8 +14,7 @@
 #include <asm/types.h>
 #include <wait_bit.h>
 
-#if defined(CONFIG_MX6QDL) || defined(CONFIG_MX6Q) || defined(CONFIG_MX6D)
-
+#if defined(CONFIG_MX6_DDRCAL)
 static void reset_read_data_fifos(void)
 {
 	struct mmdc_p_regs *mmdc0 = (struct mmdc_p_regs *)MMDC_P0_BASE_ADDR;

arch/arm/include/asm/arch-mx6/mx6-ddr.h

@@ -458,7 +458,7 @@ void mx6sl_dram_iocfg(unsigned width,
 		      const struct mx6sl_iomux_ddr_regs *,
 		      const struct mx6sl_iomux_grp_regs *);
 
-#if defined(CONFIG_MX6QDL) || defined(CONFIG_MX6Q) || defined(CONFIG_MX6D)
+#if defined(CONFIG_MX6_DDRCAL)
 int mmdc_do_write_level_calibration(struct mx6_ddr_sysinfo const *sysinfo);
 int mmdc_do_dqs_calibration(struct mx6_ddr_sysinfo const *sysinfo);
 void mmdc_read_calibration(struct mx6_ddr_sysinfo const *sysinfo,

configs/novena_defconfig

@@ -3,6 +3,7 @@ CONFIG_ARCH_MX6=y
 CONFIG_SPL_GPIO_SUPPORT=y
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
+CONFIG_MX6_DDRCAL=y
 CONFIG_TARGET_KOSAGI_NOVENA=y
 CONFIG_SPL_EXT_SUPPORT=y
 CONFIG_SPL_FAT_SUPPORT=y