Merge branch '2020-09-16-assorted-fixes'

- Assorted bug fixes

MAINTAINERS

@@ -619,7 +619,7 @@ F:	drivers/mtd/jedec_flash.c
 CLOCK
 M:	Lukasz Majewski <lukma@denx.de>
 S:	Maintained
-T:	git git://git.denx.de/u-boot-dfu.git
+T:	git https://gitlab.denx.de/u-boot/custodians/u-boot-clk.git
 F:	drivers/clk/
 F:	drivers/clk/imx/
 
@@ -983,6 +983,8 @@ F:	include/spmi/
 
 SQUASHFS
 M:	Joao Marcos Costa <joaomarcos.costa@bootlin.com>
+R:	Thomas Petazzoni <thomas.petazzoni@bootlin.com>
+R:	Miquel Raynal <miquel.raynal@bootlin.com>
 S:	Maintained
 F:	fs/squashfs/
 F:	include/sqfs.h

doc/board/emulation/qemu-arm.rst

@@ -80,3 +80,13 @@ can be enabled with the following command line parameters:
     -drive if=none,file=disk.img,id=mydisk -device nvme,drive=mydisk,serial=foo
 
 These have been tested in QEMU 2.9.0 but should work in at least 2.5.0 as well.
+
+Debug UART
+----------
+
+The debug UART on the ARM virt board uses these settings::
+
+    CONFIG_DEBUG_UART=y
+    CONFIG_DEBUG_UART_PL010=y
+    CONFIG_DEBUG_UART_BASE=0x9000000
+    CONFIG_DEBUG_UART_CLOCK=0

include/phy.h

@@ -205,7 +205,7 @@ static inline int phy_write(struct phy_device *phydev, int devad, int regnum,
 {
 	struct mii_dev *bus = phydev->bus;
 
-	if (!bus || !bus->read) {
+	if (!bus || !bus->write) {
 		debug("%s: No bus configured\n", __func__);
 		return -1;
 	}

lib/fdtdec.c

@@ -1101,7 +1101,7 @@ int fdtdec_setup_memory_banksize(void)
 		if (ret < 0) {
 			reg = 0;
 			mem = get_next_memory_node(mem);
-			if (ofnode_valid(mem))
+			if (!ofnode_valid(mem))
 				break;
 
 			ret = ofnode_read_resource(mem, reg++, &res);
@@ -1146,7 +1146,7 @@ int fdtdec_setup_mem_size_base_lowest(void)
 		if (ret < 0) {
 			reg = 0;
 			mem = get_next_memory_node(mem);
-			if (ofnode_valid(mem))
+			if (!ofnode_valid(mem))
 				break;
 
 			ret = ofnode_read_resource(mem, reg++, &res);