net: remove CONFIG_NET_MULTI

This macro is defined, but not referenced by anyone.

I did not touch config_whitelist.txt - the CONFIG will be dropped
by the next re-sync.
Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>
Reviewed-by: NYork Sun <york.sun@nxp.com>

include/configs/am335x_shc.h

@@ -266,7 +266,6 @@
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_SUBNETMASK
 #define CONFIG_NET_RETRY_COUNT         10
-#define CONFIG_NET_MULTI
 #define CONFIG_PHY_ADDR			0
 #define CONFIG_PHY_SMSC
 

include/configs/blanche.h

@@ -65,7 +65,6 @@
 #undef  CONFIG_CMD_SPI
 #endif
 
-#define CONFIG_NET_MULTI
 
 /* Board Clock */
 #define RMOBILE_XTAL_CLK	20000000u

include/configs/cm_t43.h

@@ -50,7 +50,6 @@
 #define CONFIG_BOOTP_DEFAULT
 #define CONFIG_BOOTP_SEND_HOSTNAME
 #define CONFIG_BOOTP_GATEWAY
-#define CONFIG_NET_MULTI
 #define CONFIG_PHY_ATHEROS
 #define CONFIG_SYS_RX_ETH_BUFFER	64
 

include/configs/cyrus.h

@@ -370,7 +370,6 @@
 
 #ifdef CONFIG_PCI
 #define CONFIG_PCI_INDIRECT_BRIDGE
-#define CONFIG_NET_MULTI
 
 #define CONFIG_PCI_SCAN_SHOW		/* show pci devices on startup */
 #endif	/* CONFIG_PCI */

include/configs/ls1012aqds.h

@@ -146,7 +146,6 @@
 
 #define CONFIG_PCIE1		/* PCIE controller 1 */
 
-#define CONFIG_NET_MULTI
 #define CONFIG_PCI_SCAN_SHOW
 
 #define CONFIG_CMD_MEMINFO

include/configs/ls1012ardb.h

@@ -62,7 +62,6 @@
 
 #define CONFIG_PCIE1		/* PCIE controller 1 */
 
-#define CONFIG_NET_MULTI
 #define CONFIG_PCI_SCAN_SHOW
 
 #define CONFIG_CMD_MEMINFO

include/configs/ls1043a_common.h

@@ -165,7 +165,6 @@
 #define CONFIG_PCIE3		/* PCIE controller 3 */
 
 #ifdef CONFIG_PCI
-#define CONFIG_NET_MULTI
 #define CONFIG_PCI_SCAN_SHOW
 #endif
 #endif

include/configs/nsa310s.h

@@ -67,7 +67,6 @@
 /* Ethernet driver configuration */
 #ifdef CONFIG_CMD_NET
 #define CONFIG_NETCONSOLE
-#define CONFIG_NET_MULTI
 #define CONFIG_MVGBE_PORTS	{1, 0}	/* enable port 0 only */
 #define CONFIG_PHY_BASE_ADR	1
 #define CONFIG_RESET_PHY_R

include/configs/pengwyn.h

@@ -182,9 +182,6 @@
 /* Disable CPSW SPL support so we fit within the 101KiB limit. */
 #endif
 
-/* CPSW ethernet */
-#define CONFIG_NET_MULTI
-
 /* Network */
 #define CONFIG_PHY_RESET	1
 #define CONFIG_PHY_NATSEMI

include/configs/salvator-x.h

@@ -25,7 +25,6 @@
 /* use to RPC(SPI Multi I/O Bus Controller) */
 
 /* Ethernet RAVB */
-#define CONFIG_NET_MULTI
 #define CONFIG_BITBANGMII
 #define CONFIG_BITBANGMII_MULTI
 

include/configs/ulcb.h

@@ -33,7 +33,6 @@
 /* use to RPC(SPI Multi I/O Bus Controller) */
 
 /* Ethernet RAVB */
-#define CONFIG_NET_MULTI
 #define CONFIG_PHY_MICREL
 #define CONFIG_BITBANGMII
 #define CONFIG_BITBANGMII_MULTI

include/configs/xilinx_zynqmp.h

@@ -131,7 +131,6 @@
 
 /* Ethernet driver */
 #if defined(CONFIG_ZYNQ_GEM)
-# define CONFIG_NET_MULTI
 # define CONFIG_MII
 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
 # define CONFIG_PHY_MARVELL