spi: ti_qspi: Fix failure on multiple READ_ID cmd

Populating QSPI_RD_SNGL bit(0x1) in priv->cmd means that value
QSPI_INVAL (0x4) is not written to CMD field of QSPI_SPI_CMD_REG in
ti_qspi_cs_deactivate(). Therefore CS is never deactivated between
successive READ ID which results in sf probe to fail.
Fix this by not populating priv->cmd with QSPI_RD_SNGL and OR it wih
priv->cmd as required (similar to the convention followed in the
driver).
Signed-off-by: NVignesh R <vigneshr@ti.com>
Reviewed-by: NJagan Teki <jteki@openedev.com>
Reviewed-by: NMugunthan V N <mugunthanvnm@ti.com>

drivers/spi/ti_qspi.c

@@ -247,13 +247,12 @@ static int __ti_qspi_xfer(struct ti_qspi_priv *priv, unsigned int bitlen,
 			debug("tx done, status %08x\n", status);
 		}
 		if (rxp) {
-			priv->cmd |= QSPI_RD_SNGL;
 			debug("rx cmd %08x dc %08x\n",
-			      priv->cmd, priv->dc);
+			      ((u32)(priv->cmd | QSPI_RD_SNGL)), priv->dc);
 			#ifdef CONFIG_DRA7XX
 				udelay(500);
 			#endif
-			writel(priv->cmd, &priv->base->cmd);
+			writel(priv->cmd | QSPI_RD_SNGL, &priv->base->cmd);
 			status = readl(&priv->base->status);
 			timeout = QSPI_TIMEOUT;
 			while ((status & QSPI_WC_BUSY) != QSPI_XFER_DONE) {