ARMV7: Fix udelay for OMAP4

The OMAP4 x-load code sets gptimer1 clock source to 32Khz.  This isn't
acceptable for udelay.  This patch changes from gptimer1 to gptimer2,
which uses sys_clk at 38.4 Mhz.
Signed-off-by: NSteve Sakoman <steve@sakoman.com>
Signed-off-by: NSandeep Paulraj <s-paulraj@ti.com>

arch/arm/cpu/armv7/omap-common/timer.c

@@ -41,12 +41,8 @@ static struct gptimer *timer_base = (struct gptimer *)CONFIG_SYS_TIMERBASE;
 
 /*
  * Nothing really to do with interrupts, just starts up a counter.
- * We run the counter with 13MHz, divided by 8, resulting in timer
- * frequency of 1.625MHz. With 32bit counter register, counter
- * overflows in ~44min
  */
 
-/* 13MHz / 8 = 1.625MHz */
 #define TIMER_CLOCK	(V_SCLK / (2 << CONFIG_SYS_PTV))
 #define TIMER_LOAD_VAL	0xffffffff
 
@@ -84,11 +80,6 @@ void set_timer(ulong t)
 /* delay x useconds */
 void __udelay(unsigned long usec)
 {
-#if defined(CONFIG_OMAP44XX)
-	/* TODO temporary hack until OMAP4 clock setup routines are present */
-	if (usec > 1000)
-		usec = usec/1000;
-#endif
 	long tmo = usec * (TIMER_CLOCK / 1000) / 1000;
 	unsigned long now, last = readl(&timer_base->tcrr);
 

include/configs/omap4_panda.h

@@ -196,7 +196,7 @@
 #define CONFIG_SYS_LOAD_ADDR		0x80000000
 
 /* Use General purpose timer 1 */
-#define CONFIG_SYS_TIMERBASE		GPT1_BASE
+#define CONFIG_SYS_TIMERBASE		GPT2_BASE
 #define CONFIG_SYS_PTV			2	/* Divisor: 2^(PTV+1) => 8 */
 #define CONFIG_SYS_HZ			1000
 

include/configs/omap4_sdp4430.h

@@ -197,7 +197,7 @@
 #define CONFIG_SYS_LOAD_ADDR		0x80000000
 
 /* Use General purpose timer 1 */
-#define CONFIG_SYS_TIMERBASE		GPT1_BASE
+#define CONFIG_SYS_TIMERBASE		GPT2_BASE
 #define CONFIG_SYS_PTV			2	/* Divisor: 2^(PTV+1) => 8 */
 #define CONFIG_SYS_HZ			1000