board: freescale: ls2080a/ls2088a: Enable PPA

Enable PPA on LS2080A, LS2088A boards:
-LS2080ARDB, LS2080AQDS
-LS2088ARDB, LS2088AQDS
Signed-off-by: NSantan Kumar <santan.kumar@nxp.com>
Signed-off-by: NAbhimanyu Saini <abhimanyu.saini@nxp.com>
Signed-off-by: NPriyanka Jain <priyanka.jain@nxp.com>
Reviewed-by: NYork Sun <york.sun@nxp.com>

arch/arm/cpu/armv8/fsl-layerscape/Kconfig

@@ -149,6 +149,7 @@ config SYS_LS_PPA_FW_ADDR
 	hex "Address of PPA firmware loading from"
 	depends on FSL_LS_PPA
 	default 0x40500000 if SYS_LS_PPA_FW_IN_XIP && QSPI_BOOT
+	default 0x580a00000 if SYS_LS_PPA_FW_IN_XIP && ARCH_LS2080A
 	default 0x60500000 if SYS_LS_PPA_FW_IN_XIP
 	help
 	  If the PPA firmware locate at XIP flash, such as NOR or

board/freescale/ls2080aqds/ls2080aqds.c

@@ -19,6 +19,8 @@
 #include <asm/arch/soc.h>
 #include <hwconfig.h>
 #include <fsl_sec.h>
+#include <asm/arch/ppa.h>
+
 
 #include "../common/qixis.h"
 #include "ls2080aqds_qixis.h"
@@ -224,6 +226,11 @@ int board_init(void)
 #endif
 	select_i2c_ch_pca9547(I2C_MUX_CH_DEFAULT);
 	rtc_enable_32khz_output();
+
+#ifdef CONFIG_FSL_LS_PPA
+	ppa_init();
+#endif
+
 #ifdef CONFIG_FSL_CAAM
 	sec_init();
 #endif

board/freescale/ls2080ardb/ls2080ardb.c

@@ -19,6 +19,7 @@
 #include <i2c.h>
 #include <asm/arch/mmu.h>
 #include <asm/arch/soc.h>
+#include <asm/arch/ppa.h>
 #include <fsl_sec.h>
 
 #include "../common/qixis.h"
@@ -181,6 +182,10 @@ int board_init(void)
 
 	QIXIS_WRITE(rst_ctl, QIXIS_RST_CTL_RESET_EN);
 
+#ifdef CONFIG_FSL_LS_PPA
+	ppa_init();
+#endif
+
 #ifdef CONFIG_FSL_MC_ENET
 	/* invert AQR405 IRQ pins polarity */
 	out_le32(irq_ccsr + IRQCR_OFFSET / 4, AQR405_IRQ_MASK);

configs/ls2080aqds_defconfig

 CONFIG_ARM=y
 CONFIG_TARGET_LS2080AQDS=y
+CONFIG_FSL_LS_PPA=y
 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls2080a-qds"
 # CONFIG_SYS_MALLOC_F is not set
 CONFIG_FIT=y

configs/ls2080ardb_defconfig

 CONFIG_ARM=y
 CONFIG_TARGET_LS2080ARDB=y
+CONFIG_FSL_LS_PPA=y
 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls2080a-rdb"
 # CONFIG_SYS_MALLOC_F is not set
 CONFIG_FIT=y