bootcount: display5: config: Enable boot count feature in the display5 board

The boot count is enabled in both SPL and proper u-boot.
Signed-off-by: NLukasz Majewski <lukma@denx.de>
Reviewed-by: NStefan Roese <sr@denx.de>

configs/display5_defconfig

@@ -16,6 +16,7 @@ CONFIG_SPL_LOAD_FIT=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/spl_sd.cfg,MX6Q"
 CONFIG_SUPPORT_RAW_INITRD=y
+CONFIG_SPL_BOOTCOUNT_LIMIT=y
 # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set
 CONFIG_SPL_DMA_SUPPORT=y
 CONFIG_SPL_ENV_SUPPORT=y
@@ -53,6 +54,9 @@ CONFIG_EFI_PARTITION=y
 CONFIG_OF_CONTROL=y
 CONFIG_ENV_IS_IN_SPI_FLASH=y
 CONFIG_FSL_ESDHC=y
+CONFIG_BOOTCOUNT_LIMIT=y
+CONFIG_SYS_BOOTCOUNT_SINGLEWORD=y
+CONFIG_SYS_BOOTCOUNT_ADDR=0x020CC068
 CONFIG_SPI_FLASH=y
 CONFIG_SPI_FLASH_BAR=y
 CONFIG_SPI_FLASH_SPANSION=y