fpga: zynqpl: Check fpga config completion

This patch checks fpga config completion when a bitstream is loaded
into PL.
Signed-off-by: NT Karthik Reddy <t.karthik.reddy@xilinx.com>
Signed-off-by: NSiva Durga Prasad Paladugu <siva.durga.paladugu@xilinx.com>
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

drivers/fpga/zynqpl.c

@@ -514,6 +514,8 @@ struct xilinx_fpga_op zynq_op = {
 int zynq_decrypt_load(u32 srcaddr, u32 srclen, u32 dstaddr, u32 dstlen,
 		      u8 bstype)
 {
+	u32 isr_status, ts;
+
 	if (srcaddr < SZ_1M || dstaddr < SZ_1M) {
 		printf("%s: src and dst addr should be > 1M\n",
 		       __func__);
@@ -544,8 +546,21 @@ int zynq_decrypt_load(u32 srcaddr, u32 srclen, u32 dstaddr, u32 dstlen,
 	if (zynq_dma_transfer(srcaddr | 1, srclen, dstaddr | 1, dstlen))
 		return FPGA_FAIL;
 
-	writel((readl(&devcfg_base->ctrl) & ~DEVCFG_CTRL_PCAP_RATE_EN_MASK),
-	       &devcfg_base->ctrl);
+	if (bstype == BIT_FULL) {
+		isr_status = readl(&devcfg_base->int_sts);
+		/* Check FPGA configuration completion */
+		ts = get_timer(0);
+		while (!(isr_status & DEVCFG_ISR_PCFG_DONE)) {
+			if (get_timer(ts) > CONFIG_SYS_FPGA_WAIT) {
+				printf("%s: Timeout wait for FPGA to config\n",
+				       __func__);
+				return FPGA_FAIL;
+			}
+			isr_status = readl(&devcfg_base->int_sts);
+		}
+		printf("%s: FPGA config done\n", __func__);
+		zynq_slcr_devcfg_enable();
+	}
 
 	return FPGA_SUCCESS;
 }