display5: config: Reset the board when bootm fails

Since display5 is now supporting boot counting, we can just reset the
board when bootm fails (i.e. it doesn't boot the fitImage kernel for
any reason).
Signed-off-by: NLukasz Majewski <lukma@denx.de>

include/configs/display5.h

@@ -151,7 +151,7 @@
 	"sf probe;" \
 	"sf read ${loadaddr} swu-kernel;" \
 	"sf read ${loadaddr_swu_initramfs} swu-initramfs;" \
-	"bootm ${loadaddr} ${loadaddr_swu_initramfs};"
+	"bootm ${loadaddr} ${loadaddr_swu_initramfs};reset;"
 
 #define KERNEL_RECOVERY_PROCEDURE \
 	"echo '#######################';" \
@@ -159,7 +159,7 @@
 	"echo '#######################';" \
 	"sf probe;" \
 	"sf read ${loadaddr} lin-recovery;" \
-	"bootm;"
+	"bootm;reset;"
 
 #define SETUP_BOOTARGS \
 	"run set_rootfs_part;" \
@@ -309,7 +309,7 @@
 	"if run download_kernel; then "	  \
 	     "setenv bootargs console=${console} " \
 	     "root=/dev/mmcblk0p2 rootwait;" \
-	     "bootm ${loadaddr} - ${fdtaddr};" \
+	     "bootm ${loadaddr} - ${fdtaddr};reset;" \
 	"fi\0" \
 	"addip=setenv bootargs ${bootargs} " \
 	"ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:" \
@@ -326,7 +326,7 @@
 	     "run addip;"	  \
 	     "setenv bootargs ${bootargs} console=${console};"	  \
 	     "setenv fdt_conf imx6q-${board}-${display}.dtb; " \
-	     "bootm ${loadaddr}#conf@${fdt_conf};" \
+	     "bootm ${loadaddr}#conf@${fdt_conf};reset;" \
 	"fi\0" \
 	"falcon_setup=" \
 	"if mmc dev ${mmcdev}; then "	  \
@@ -340,7 +340,7 @@
 	"boot_mmc=" \
 	"if mmc dev ${mmcdev}; then "	  \
 	     SETUP_BOOTARGS \
-	     "bootm ${loadaddr}#conf@${fdt_conf};" \
+	     "bootm ${loadaddr}#conf@${fdt_conf};reset;" \
 	"fi\0" \
 	"set_kernel_part=" \
 	"if test ${BOOT_FROM} = ACTIVE; then " \