提交 0bdea7c4 编写于 作者: T Tom Rini

CONFIG_SYS_GENERIC_BOARD: Finish migration

While we have long since migrated to CONFIG_SYS_GENERIC_BOARD being
enabled, we had just a few places left that still referenced or defined
it.  Update.
Signed-off-by: NTom Rini <trini@konsulko.com>
上级 92e738f5
......@@ -13,26 +13,8 @@
#ifndef _XTENSA_U_BOOT_H
#define _XTENSA_U_BOOT_H
#ifdef CONFIG_SYS_GENERIC_BOARD
/* Use the generic board which requires a unified bd_info */
#include <asm-generic/u-boot.h>
#else
#ifndef __ASSEMBLY__
typedef struct bd_info {
int bi_baudrate; /* serial console baudrate */
unsigned long bi_ip_addr; /* IP Address */
unsigned char bi_enetaddr[6]; /* Ethernet adress */
unsigned long bi_boot_params; /* where this board expects params */
unsigned long bi_memstart; /* start of DRAM memory VA */
unsigned long bi_memsize; /* size of DRAM memory in bytes */
unsigned long bi_flashstart; /* start of FLASH memory */
unsigned long bi_flashsize; /* size of FLASH memory */
unsigned long bi_flashoffset; /* offset to skip UBoot image */
} bd_t;
#endif /* __ ASSEMBLY__ */
#endif /* CONFIG_SYS_GENERIC_BOARD */
/* For image.h:image_check_target_arch() */
#define IH_ARCH_DEFAULT IH_ARCH_XTENSA
......
......@@ -14,8 +14,6 @@
#define CONFIG_MACH_TYPE 4886
#define CONFIG_SYS_GENERIC_BOARD
#include <asm/arch/imx-regs.h>
#include <asm/mach-imx/gpio.h>
......
......@@ -32,11 +32,6 @@ extern phys_addr_t prior_stage_fdt_address;
#endif /* __ASSEMBLY__ */
/*
* Generic board configuration.
*/
#define CONFIG_SYS_GENERIC_BOARD
/*
* CPU configuration.
*/
......
......@@ -12,8 +12,6 @@
#undef CONFIG_DISPLAY_BOARDINFO
#define CONFIG_SYS_GENERIC_BOARD
#include <asm/arch/imx-regs.h>
#include <asm/mach-imx/gpio.h>
......
......@@ -2992,7 +2992,6 @@ CONFIG_SYS_GBIT_MII1_BUSNAME
CONFIG_SYS_GBIT_MII_BUSNAME
CONFIG_SYS_GBL_DATA_OFFSET
CONFIG_SYS_GBL_DATA_SIZE
CONFIG_SYS_GENERIC_BOARD
CONFIG_SYS_GIC400_ADDR
CONFIG_SYS_GP1DIR
CONFIG_SYS_GP1ODR
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册