mtd: denali: fix NAND_CMD_PARAM command

NAND_CMD_PARAM (0xEC) command is not working on the Denali
NAND controller driver.

Unlike NAND_CMD_READID (0x90), when the NAND_CMD_PARAM command
is followed by an address cycle, the target device goes busy.
(R/B# is deasserted)
Wait until the parameter data are ready.

In addition, unnecessary clear_interrupts() should be removed.
Signed-off-by: NMasahiro Yamada <yamada.m@jp.panasonic.com>
Acked-by: NChin Liang See <clsee@altera.com>

drivers/mtd/nand/denali.c

@@ -1059,9 +1059,8 @@ static void denali_cmdfunc(struct mtd_info *mtd, unsigned int cmd, int col,
 		addr = MODE_11 | BANK(denali->flash_bank);
 		index_addr(denali, addr | 0, cmd);
 		break;
-	case NAND_CMD_PARAM:
-		clear_interrupts(denali);
 	case NAND_CMD_READID:
+	case NAND_CMD_PARAM:
 		reset_buf(denali);
 		/* sometimes ManufactureId read from register is not right
 		 * e.g. some of Micron MT29F32G08QAA MLC NAND chips
@@ -1070,6 +1069,8 @@ static void denali_cmdfunc(struct mtd_info *mtd, unsigned int cmd, int col,
 		addr = MODE_11 | BANK(denali->flash_bank);
 		index_addr(denali, addr | 0, cmd);
 		index_addr(denali, addr | 1, col & 0xFF);
+		if (cmd == NAND_CMD_PARAM)
+			udelay(50);
 		break;
 	case NAND_CMD_READ0:
 	case NAND_CMD_SEQIN: