提交 e2fc252e 编写于 作者: P Paul Jackson 提交者: Ingo Molnar

x86 boot: show pfn addresses in hex not decimal in some kernel info printks

Page frame numbers (the portion of physical addresses above the low
order page offsets) are displayed in several kernel debug and info
prints in decimal, not hex.  Decimal addresse are unreadable.  Use hex.
Signed-off-by: NPaul Jackson <pj@sgi.com>
Cc: "Yinghai Lu" <yhlu.kernel@gmail.com>
Cc: "Jack Steiner" <steiner@sgi.com>
Cc: "Mike Travis" <travis@sgi.com>
Cc: "Huang
Cc: Ying" <ying.huang@intel.com>
Cc: "Andi Kleen" <andi@firstfloor.org>
Cc: "Andrew Morton" <akpm@linux-foundation.org>
Cc: Paul Jackson <pj@sgi.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
上级 c4ba1320
......@@ -990,7 +990,7 @@ unsigned long __init e820_end_of_ram(void)
if (last_pfn > end_user_pfn)
last_pfn = end_user_pfn;
printk(KERN_INFO "last_pfn = %lu max_arch_pfn = %lu\n",
printk(KERN_INFO "last_pfn = 0x%lx max_arch_pfn = 0x%lx\n",
last_pfn, max_arch_pfn);
return last_pfn;
}
......
......@@ -3520,7 +3520,7 @@ void __init add_active_range(unsigned int nid, unsigned long start_pfn,
{
int i;
printk(KERN_DEBUG "Entering add_active_range(%d, %lu, %lu) "
printk(KERN_DEBUG "Entering add_active_range(%d, 0x%lx, 0x%lx) "
"%d entries of %d used\n",
nid, start_pfn, end_pfn,
nr_nodemap_entries, MAX_ACTIVE_REGIONS);
......@@ -3936,7 +3936,7 @@ void __init free_area_init_nodes(unsigned long *max_zone_pfn)
for (i = 0; i < MAX_NR_ZONES; i++) {
if (i == ZONE_MOVABLE)
continue;
printk(" %-8s %8lu -> %8lu\n",
printk(" %-8s 0x%8lx -> 0x%8lx\n",
zone_names[i],
arch_zone_lowest_possible_pfn[i],
arch_zone_highest_possible_pfn[i]);
......@@ -3952,7 +3952,7 @@ void __init free_area_init_nodes(unsigned long *max_zone_pfn)
/* Print out the early_node_map[] */
printk("early_node_map[%d] active PFN ranges\n", nr_nodemap_entries);
for (i = 0; i < nr_nodemap_entries; i++)
printk(" %3d: %8lu -> %8lu\n", early_node_map[i].nid,
printk(" %3d: 0x%8lx -> 0x%8lx\n", early_node_map[i].nid,
early_node_map[i].start_pfn,
early_node_map[i].end_pfn);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册