as a shared library without RSA.  Use #ifndef NO_SSL2 instead of
NO_RSA in ssl/s2*.c.

Submitted by: Kris Kennaway <kris@hub.freebsd.org>
Modified by Ulf Möller

set the #! line with the path to Perl.

Submitted by: Peter Jones

problem was that one of the replacement routines had not been working since
SSLeay releases.  For now the offending routine has been replaced with
non-optimised assembler.  Even so, this now gives around 95% performance
improvement for 1024 bit RSA signs.

Submitted by: Lennart Bång, Bodo Möller

platforms. See crypto/rc4/rc4_enc.c for further details.

Contributed by: Peter Huang <PETER_HUANG@HP-Cupertino-om8.om.hp.com>

because various programs are not updated that often
and hence still expect header files names without the openssl/ prefix.

Submitted by: Even Holen <Even.Holen@itea.ntnu.no>

Everyone should have got it by now.

Modify obj_dat.pl to take its files from the command line. Usage is now
perl obj_dat.pl objects.h obj_dat.h
this should avoid redirection shell escape problems under Win32.

| revision 1.109
| date: 1999/06/24 19:39:23;  author: ulf;  state: Exp;  lines: +0 -1
| Use the same CPU recogition method for FreeBSD 3 as for the other FreeBSD
| versions. (The FreeBSD and FreeBSD-elf Configure entries were identical.)

Because Ulf overlooked the ELF vs. a.out difference, i.e. the two entries were
_NOT_ identical! This way OpenSSL 0.9.4 at least compiles again under FreeBSD
2 and 3. For 0.9.5-dev I'll try to fix the stuff in a more general way to also
allow FreeBSD 4 and other variants.

command shell which means that redirecttion needs backslashes in the paths.

Using different files caused problems because the dependencies
in the Makefiles produced by mk1mf.pl were for the standard case,
i.e. mentioned buildinf.h and not mk1mfinf.h.

./config sences whole range of SPARC instruction sets. Do note that
it favors Sun C now if both gcc and cc 4.2 or later are present!

use new file buildinf.h instead.