提交 8f06ab0e 编写于 作者: R Rich Felker

fix out-of-bounds access in UTF-8 decoding

SA and SB are used as the lowest and highest valid starter bytes, but
the value of SB was one-past the last valid starter. this caused
access past the end of the state table when the illegal byte '\xf5'
was encountered in a starter position. the error did not show up in
full-character decoding tests, since the bogus state read from just
past the table was unlikely to admit any continuation bytes as valid,
but would have shown up had we tested feeding '\xf5' to the
byte-at-a-time decoding in mbrtowc: it would cause the funtion to
wrongly return -2 rather than -1.

I may eventually go back and remove all references to SA and SB,
replacing them with the values; this would make the code more
transparent, I think. the original motivation for using macros was to
allow misguided users of the code to redefine them for the purpose of
enlarging the set of accepted sequences past the end of Unicode...
上级 bcd93025
......@@ -19,4 +19,4 @@ extern const uint32_t bittab[] ATTR_LIBC_VISIBILITY;
#define FAILSTATE R(0x80,0x80)
#define SA 0xc2u
#define SB 0xf5u
#define SB 0xf4u
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册