Conflicts:

	drivers/net/wireless/rt2x00/Kconfig
	drivers/net/wireless/rt2x00/rt2x00usb.c
	net/sctp/protocol.c

Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

From: "Robert T. Johnson" <rtjohnso@eecs.berkeley.edu>
Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>

From: Eric Kinzie <ekinzie@cmf.nrl.navy.mil>
Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This causes the suni driver to oops if you try to use sonetdiag to get
the statistics. Also add the corresponding phy->stop call to fix another
oops if you try to remove the module.
Signed-off-by: NJorge Boncompte [DTI2] <jorge@dti2.net>
Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJorge Boncompte [DTI2] <jorge@dti2.net>
Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

It happens that if a packet arrives in a VC between the call to open it on
the hardware and the call to change the backend to br2684, br2684_regvcc
processes the packet and oopses dereferencing skb->dev because it is
NULL before the call to br2684_push().
Signed-off-by: NJorge Boncompte [DTI2] <jorge@dti2.net>
Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>

There are many possible ways to add this "salt", thus I made this
patch to be the last in the series to change it if required.

Currently I propose to use the struct net pointer itself as this 
salt, but since this pointer is most often cache-line aligned, shift 
this right to eliminate the bits, that are most often zeroed.

After this, simply add this mix to prepared hashfn-s.

For CONFIG_NET_NS=n case this salt is 0 and no changes in hashfn
appear.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Same as for inet_hashfn, prepare its ipv6 incarnation.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Although this hash takes addresses into account, the ehash chains
can also be too long when, for instance, communications via lo occur.
So, prepare the inet_hashfn to take struct net into account.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Listening-on-one-port sockets in many namespaces produce long 
chains in the listening_hash-es, so prepare the inet_lhashfn to 
take struct net into account.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Binding to some port in many namespaces may create too long
chains in bhash-es, so prepare the hashfn to take struct net
into account.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Every caller already has this one. The new argument is currently 
unused, but this will be fixed shortly.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

They both calculate the hash chain, but currently do not have
a struct net pointer, so pass one there via additional argument,
all the more so their callers already have such.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Currently the chain to store a UDP socket is calculated with
simple (x & (UDP_HTABLE_SIZE - 1)). But taking net into account
would make this calculation a bit more complex, so moving it into
a function would help.
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

1) Remove ICMP_MIN_LENGTH, as it is unused.

2) Remove unneeded tcp_v4_send_check() declaration.
Signed-off-by: NRami Rosen <ramirose@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

I just noticed "cat /proc/net/raw" was buggy, missing '\n' separators.

I believe this was introduced by commit 8cd850ef 
([RAW]: Cleanup IPv4 raw_seq_show.)

This trivial patch restores correct behavior, and applies to current 
Linus tree (should also be applied to stable tree as well.)
Signed-off-by: NEric Dumazet <dada1@cosmosbay.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Selected device feature bits can be propagated to VLAN devices, so we
can make use of TX checksum offload and TSO on VLAN-tagged packets.
However, if the physical device does not do VLAN tag insertion or
generic checksum offload then the test for TX checksum offload in
dev_queue_xmit() will see a protocol of htons(ETH_P_8021Q) and yield
false.

This splits the checksum offload test into two functions:

- can_checksum_protocol() tests a given protocol against a feature bitmask

- dev_can_checksum() first tests the skb protocol against the device
  features; if that fails and the protocol is htons(ETH_P_8021Q) then
  it tests the encapsulated protocol against the effective device
  features for VLANs
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Acked-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Right now, any time we set a primary transport we set
the changeover_active flag.  As a result, we invoke SFR-CACC
even when there has been no changeover events.

Only set changeover_active, when there is a true changeover
event, i.e. we had a primary path and we are changing to
another transport.
Signed-off-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This patch remove the proc fs entry which has been created if fail to
set up proc fs entry for the SCTP protocol.
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Acked-by: NNeil Horman <nhorman@tuxdriver.com>
Signed-off-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Ingo's system is still seeing strange behavior, and he
reports that is goes away if the rest of the deferred
accept changes are reverted too.

Therefore this reverts e4c78840
("[TCP]: TCP_DEFER_ACCEPT updates - dont retxmt synack") and
539fae89 ("[TCP]: TCP_DEFER_ACCEPT
updates - defer timeout conflicts with max_thresh").

Just like the other revert, these ideas can be revisited for
2.6.27
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

We've introduced extra need of compat layer for ip_tunnel_prl{}
for PRL (Potential Router List) management.  Though compat_ioctl
is still missing in ipv4/ipv6, let's make the interface more
straight-forward and eliminate extra need for nasty compat layer
anyway since the interface is new for 2.6.26.
Signed-off-by: NYOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Add a htb_hysteresis parameter to htb_sch.ko and by sysfs magic make
it runtime adjustable via
/sys/module/sch_htb/parameters/htb_hysteresis mode 640.
Signed-off-by: NJesper Dangaard Brouer <hawk@comx.dk>
Acked-by: NMartin Devera <devik@cdi.cz>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The HTB hysteresis mode reduce the CPU load, but at the
cost of scheduling accuracy.

On ADSL links (512 kbit/s upstream), this inaccuracy introduce
significant jitter, enought to disturbe VoIP.  For details see my
masters thesis (http://www.adsl-optimizer.dk/thesis/), chapter 7,
section 7.3.1, pp 69-70.
Signed-off-by: NJesper Dangaard Brouer <hawk@comx.dk>
Acked-by: NMartin Devera <devik@cdi.cz>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Change struct proto destroy function pointer to return void.  Noticed
by Al Viro.
Signed-off-by: NBrian Haley <brian.haley@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

In IBSS mode prior to join/creation of new IBSS it is possible that
a frame from unknown station is received and an ibss_add_sta() is
called. This will cause a warning in rate_lowest_index() since the
list of supported rates of our station is not initialized yet.

The fix is to add ibss stations with a rate we received that frame
at; this single-element set will be extended later based on beacon
data. Also there is no need to store stations from a foreign IBSS.
Signed-off-by: NVladimir Koutny <vlado@ksp.sk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Also change the arguments of the phase1, 2 key mixing to take
a pointer to the encrytion key and the tkip_ctx in the same
order.

Do the dereference of the encryption key in the callers.
Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Take a __le16 directly rather than a host-endian value.
Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Many callers already expect it to.
Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Replaced by the new helper ieee80211_has_morefrags which is
more consistent with the intent of the function.
Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

A few general categories:

1) ieee80211_has_* tests if particular fctl bits are set, the helpers are de
in the same order as the fctl defines:

A combined _has_a4 was also added to test when both FROMDS and TODS are set.

2) ieee80211_is_* is meant to test whether the frame control is of a certain
ftype - data, mgmt, ctl, and two special helpers _is_data_qos, _is_data_pres
which also test a subset of the stype space.

When testing for a particular stype applicable only to one ftype, functions
like ieee80211_is_ack have been added.  Note that the ftype is also being
checked in these helpers.  They have been added for all mgmt and ctl stypes
in the same order as the STYPE defines.

3) ieee80211_get_* is meant to take a struct ieee80211_hdr * and returns a
pointer to somewhere in the struct, see get_SA, get_DA, get_qos_ctl.

The intel wireless drivers had helpers that used this namespace, convert the
all to use the new helpers and remove the byteshifting as they were defined
in cpu-order rather than little-endian.
Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>