Add KVM register numbers for the MIPS SIMD Architecture (MSA) registers,
and implement access to them with the KVM_GET_ONE_REG / KVM_SET_ONE_REG
ioctls when the MSA capability is enabled (exposed in a later patch) and
present in the guest according to its Config3.MSAP bit.

The MSA vector registers use the same register numbers as the FPU
registers except with a different size (128bits). Since MSA depends on
Status.FR=1, these registers are inaccessible when Status.FR=0. These
registers are returned as a single native endian 128bit value, rather
than least significant half first with each 64-bit half native endian as
the kernel uses internally.
Signed-off-by: NJames Hogan <james.hogan@imgtec.com>
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Paul Burton <paul.burton@imgtec.com>
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: Gleb Natapov <gleb@kernel.org>
Cc: Jonathan Corbet <corbet@lwn.net>
Cc: linux-mips@linux-mips.org
Cc: kvm@vger.kernel.org
Cc: linux-api@vger.kernel.org
Cc: linux-doc@vger.kernel.org

Add KVM register numbers for the MIPS FPU registers, and implement
access to them with the KVM_GET_ONE_REG / KVM_SET_ONE_REG ioctls when
the FPU capability is enabled (exposed in a later patch) and present in
the guest according to its Config1.FP bit.

The registers are accessible in the current mode of the guest, with each
sized access showing what the guest would see with an equivalent access,
and like the architecture they may become UNPREDICTABLE if the FR mode
is changed. When FR=0, odd doubles are inaccessible as they do not exist
in that mode.
Signed-off-by: NJames Hogan <james.hogan@imgtec.com>
Acked-by: NPaolo Bonzini <pbonzini@redhat.com>
Cc: Paul Burton <paul.burton@imgtec.com>
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: Gleb Natapov <gleb@kernel.org>
Cc: Jonathan Corbet <corbet@lwn.net>
Cc: linux-mips@linux-mips.org
Cc: kvm@vger.kernel.org
Cc: linux-api@vger.kernel.org
Cc: linux-doc@vger.kernel.org

Clean up KVM_GET_ONE_REG / KVM_SET_ONE_REG register definitions for
MIPS, to prepare for adding a new group for FPU & MSA vector registers.

Definitions are added for common bits in each group of registers, e.g.
KVM_REG_MIPS_CP0 = KVM_REG_MIPS | 0x10000, for the coprocessor 0
registers.
Signed-off-by: NJames Hogan <james.hogan@imgtec.com>
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: Gleb Natapov <gleb@kernel.org>
Cc: linux-mips@linux-mips.org
Cc: kvm@vger.kernel.org

Expose the KVM guest CP0_Count frequency to userland via a new
KVM_REG_MIPS_COUNT_HZ register accessible with the KVM_{GET,SET}_ONE_REG
ioctls.

When the frequency is altered the bias is adjusted such that the guest
CP0_Count doesn't jump discontinuously or lose any timer interrupts.
Signed-off-by: NJames Hogan <james.hogan@imgtec.com>
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Gleb Natapov <gleb@kernel.org>
Cc: kvm@vger.kernel.org
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: linux-mips@linux-mips.org
Cc: David Daney <david.daney@cavium.com>
Cc: Sanjay Lal <sanjayl@kymasys.com>
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>

Expose two new virtual registers to userland via the
KVM_{GET,SET}_ONE_REG ioctls.

KVM_REG_MIPS_COUNT_CTL is for timer configuration fields and just
contains a master disable count bit. This can be used by userland to
freeze the timer in order to read a consistent state from the timer
count value and timer interrupt pending bit. This cannot be done with
the CP0_Cause.DC bit because the timer interrupt pending bit (TI) is
also in CP0_Cause so it would be impossible to stop the timer without
also risking a race with an hrtimer interrupt and having to explicitly
check whether an interrupt should have occurred.

When the timer is re-enabled it resumes without losing time, i.e. the
CP0_Count value jumps to what it would have been had the timer not been
disabled, which would also be impossible to do from userland with
CP0_Cause.DC. The timer interrupt also cannot be lost, i.e. if a timer
interrupt would have occurred had the timer not been disabled it is
queued when the timer is re-enabled.

This works by storing the nanosecond monotonic time when the master
disable is set, and using it for various operations instead of the
current monotonic time (e.g. when recalculating the bias when the
CP0_Count is set), until the master disable is cleared again, i.e. the
timer state is read/written as it would have been at that time. This
state is exposed to userland via the read-only KVM_REG_MIPS_COUNT_RESUME
virtual register so that userland can determine the exact time the
master disable took effect.

This should allow userland to atomically save the state of the timer,
and later restore it.
Signed-off-by: NJames Hogan <james.hogan@imgtec.com>
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Gleb Natapov <gleb@kernel.org>
Cc: kvm@vger.kernel.org
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: linux-mips@linux-mips.org
Cc: David Daney <david.daney@cavium.com>
Cc: Sanjay Lal <sanjayl@kymasys.com>
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>

The API requires that the GET_ONE_REG and SET_ONE_REG ioctls have this
extra information encoded in the register identifiers.
Signed-off-by: NDavid Daney <david.daney@cavium.com>
Signed-off-by: NGleb Natapov <gleb@redhat.com>

Because not all 256 CP0 registers are ever implemented, we need a
different method of manipulating them.  Use the
KVM_SET_ONE_REG/KVM_GET_ONE_REG mechanism.

Now unused code and definitions are removed.
Signed-off-by: NDavid Daney <david.daney@cavium.com>
Acked-by: NSanjay Lal <sanjayl@kymasys.com>
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>

Signed-off-by: NDavid Daney <david.daney@cavium.com>
Acked-by: NSanjay Lal <sanjayl@kymasys.com>
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>

All registers are 64-bits wide, 32-bit guests use the least
significant portion of the register storage fields.
Signed-off-by: NDavid Daney <david.daney@cavium.com>
Acked-by: NSanjay Lal <sanjayl@kymasys.com>
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>

Define a non-empty struct kvm_fpu.
Signed-off-by: NDavid Daney <david.daney@cavium.com>
Acked-by: NSanjay Lal <sanjayl@kymasys.com>
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>

Signed-off-by: NSanjay Lal <sanjayl@kymasys.com>
Signed-off-by: NGleb Natapov <gleb@redhat.com>

Signed-off-by: NSanjay Lal <sanjayl@kymasys.com>
Cc: kvm@vger.kernel.org
Cc: linux-mips@linux-mips.org
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>