This header is sometimes included in the uncompress stage to get
register values, but no <linux/amba/bus.h> can be included there.
So declare "struct amba_device" here before using it in a prototype.
Signed-off-by: NAlessandro Rubini <rubini@unipv.it>
Acked-by: NAndrea Gallo <andrea.gallo@stericsson.com>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

The amba-pl010 hardware does not provide RTS and DTR control lines; it
is expected that these will be implemented using GPIO.  Allow platforms
to supply a function to implement manipulation of modem control lines.
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

Since the ARM AMBA bus is used on MIPS as well as ARM, we need
to make the bus available for other architectures to use.  Move
the AMBA include files from include/asm-arm/hardware/ to
include/linux/amba/
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

The receiver status register reports latched error conditions, which
must be cleared by writing to it.  However, the data register reports
unlatched conditions which are associated with the current character.
Use the data register to interpret error status rather than the RSR.
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!