This provides an alternate to storing the bitmap in a separate file.  The
bitmap can be stored at a given offset from the superblock.  Obviously the
creator of the array must make sure this doesn't intersect with data....
After is good for version-0.90 superblocks.
Signed-off-by: NNeil Brown <neilb@cse.unsw.edu.au>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Currently we don't wait for updates to the bitmap to be flushed to disk
properly.  The infrastructure all there, but it isn't being used....

A separate kernel thread (bitmap_writeback_daemon) is needed to wait for each
page as we cannot get callbacks when a page write completes.
Signed-off-by: NNeil Brown <neilb@cse.unsw.edu.au>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

With this patch, the intent to write to some block in the array can be logged
to a bitmap file.  Each bit represents some number of sectors and is set
before any update happens, and only cleared when all writes relating to all
sectors are complete.

After an unclean shutdown, information in this bitmap can be used to optimise
resync - only sectors which could be out-of-sync need to be updated.

Also if a drive is removed and then added back into an array, the recovery can
make use of the bitmap to optimise reconstruction.  This is not implemented in
this patch.

Currently the bitmap is stored in a file which must (obviously) be stored on a
separate device.

The patch only provided infrastructure.  It does not update any personalities
to bitmap intent logging.

Md arrays can still be used with no bitmap file.  This patch has minimal
impact on such arrays.
Signed-off-by: NNeil Brown <neilb@cse.unsw.edu.au>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>