Following patch will make the driver to use the 44.1kHz SRC automatically
if the pcm source is 44.1kHz signed 16bit stereo.
The SRC is available in YMF754 only.
Signed-off-by: NTeru KAMOGASHIRA <teru@sodan.ecc.u-tokyo.ac.jp>
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Load the DSP and controller microcode using request_firmware(), if
possible, instead of using the built-in firmware.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Fix the type of PCI revision to char from int and avoid invalid
assignment with pointer cast.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

This patch fixes incorrect assignment of swap_rear,
which was broken since patch 'ymfpci - make rear channel swap optional'
It removes module_param rear_swap.
Signed-off-by: NGlen Masgai <mimosius@gmx.de>
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: YMFPCI driver

Added rear_swap module option / kernel parameter to configure the rear
channel swapping. Default value is enable to make the AC3 passthrough
working, but analog only users might revert the previous behaviour.
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: YMFPCI driver

Fix PM support on YMFPCI driver.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: YMFPCI driver

Remove xxx_t typedefs from the PCI YMFPCI driver.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

CS46xx driver,EMU10K1/EMU10K2 driver,PCM Midlevel,Trident driver
YMFPCI driver,BT87x driver,CMIPCI driver,CS4281 driver
ENS1370/1+ driver,ES1938 driver,ES1968 driver,Intel8x0 driver
Intel8x0-modem driver,Maestro3 driver,RME32 driver,RME96 driver
SonicVibes driver,VIA82xx driver,ALI5451 driver,ICE1712 driver
ICE1724 driver,NM256 driver,RME HDSP driver,RME9652 driver
Remove superfluous PCI ID definitions.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

YMFPCI driver
Implements mixer controls for the volume of each playback substream of
the main PCM device.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!