When trying to netboot a Linksys WRT54GS WLAN router, the bootup fails,
because of following error message:

...
[    0.424000] b44: b44.c:v2.0
[    0.424000] b44: Invalid MAC address found in EEPROM
[    0.432000] b44 ssb0:1: Problem fetching invariants of chip,aborting
[    0.436000] b44: probe of ssb0:1 failed with error -22
...

The router uses a CFE bootloader, but most of the needed environment
variables for network card initialization, are not available from CFE
via printenv and even though not via cfe_getenv().
The required environment variables are saved in a special partition
in flash memory. The attached patch implement nvram_getenv and enables
bootup via NFS root on my router.

Most of the patch is extracted from the OpenWrt subversion repository and
stripped down and cleaned up to just fix this issue.

[Ralf: sorted out header file inclusions.  Lots of unneded headers and such
that should have been included.]
Signed-off-by: NWaldemar Brodkorb <wbx@openadk.org>
Reviewed-by: NPhil Sutter <phil@nwl.cc>
To: linux-mips@linux-mips.org
Cc: Hauke Mehrtens <hauke@hauke-m.de>
Patchwork: http://patchwork.linux-mips.org/patch/1359/Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Add LED support to the WGT634U machine.  It uses the new gpio-led
driver and a platform driver for the pin definitions.
Signed-off-by: NAurelien Jarno <aurelien@aurel32.net>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Add GPIO support to the BCM47XX platform.  It will be used by a GPIO
LED driver.
Signed-off-by: NAurelien Jarno <aurelien@aurel32.net>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Note that the BCM4710 does not support the wait instruction, this
is not a mistake in the code.
    
It originally comes from the OpenWrt patches.
    
Cc: Michael Buesch <mb@bu3sch.de>
Cc: Felix Fietkau <nbd@openwrt.org>
Cc: Florian Schirmer <jolt@tuxbox.org>
Signed-off-by: NAurelien Jarno <aurelien@aurel32.net>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>