Skip to content

K
kernel_linux

OpenHarmony / kernel_linux
上一次同步 大约 4 年

通知 14
Star 8
Fork 2
K
kernel_linux
切换分支/标签
  1. 06 2月, 2008 1 次提交
  3. 03 2月, 2008 1 次提交
  5. 02 2月, 2008 9 次提交
  7. 15 10月, 2007 1 次提交
  9. 13 10月, 2007 3 次提交
  11. 01 8月, 2007 1 次提交
  13. 31 7月, 2007 1 次提交
  15. 25 7月, 2007 1 次提交
  17. 22 7月, 2007 1 次提交
  19. 12 7月, 2007 4 次提交
  21. 03 5月, 2007 3 次提交
    • S
      pci: do not mark exported functions as __devinit · 96bde06a
      由 Sam Ravnborg 提交于 
      Functions marked __devinit will be removed after kernel init.  But being
exported they are potentially called by a module much later.

So the safer choice seems to be to keep the function even in the non
CONFIG_HOTPLUG case.

This silence the follwoing section mismatch warnings:
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_bus_add_device from __ksymtab_gpl between '__ksymtab_pci_bus_add_device' (at offset 0x20) and '__ksymtab_pci_walk_bus'
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_create_bus from __ksymtab_gpl between '__ksymtab_pci_create_bus' (at offset 0x40) and '__ksymtab_pci_stop_bus_device'
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_bus_max_busnr from __ksymtab_gpl between '__ksymtab_pci_bus_max_busnr' (at offset 0xc0) and '__ksymtab_pci_assign_resource_fixed'
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_claim_resource from __ksymtab_gpl between '__ksymtab_pci_claim_resource' (at offset 0xe0) and '__ksymtab_pcie_port_bus_type'
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_bus_add_devices from __ksymtab between '__ksymtab_pci_bus_add_devices' (at offset 0x70) and '__ksymtab_pci_bus_alloc_resource'
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_scan_bus_parented from __ksymtab between '__ksymtab_pci_scan_bus_parented' (at offset 0x90) and '__ksymtab_pci_root_buses'
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_bus_assign_resources from __ksymtab between '__ksymtab_pci_bus_assign_resources' (at offset 0x4d0) and '__ksymtab_pci_bus_size_bridges'
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:pci_bus_size_bridges from __ksymtab between '__ksymtab_pci_bus_size_bridges' (at offset 0x4e0) and '__ksymtab_pci_setup_cardbus'
Signed-off-by: NSam Ravnborg <sam@ravnborg.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      96bde06a
    • R
      PCI: kernel-doc fix · 8d7d86e9
      由 Randy Dunlap 提交于 
      Warning(linux-2621-rc3g7/drivers/pci/pci.c:1283): No description found for parameter 'dev'
Signed-off-by: NRandy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      8d7d86e9
    • B
      pci: New PCI-E reset API · f7bdd12d
      由 Brian King 提交于 
      Adds a new API which can be used to issue various types
of PCI-E reset, including PCI-E warm reset and PCI-E hot reset.
This is needed for an ipr PCI-E adapter which does not properly
implement BIST. Running BIST on this adapter results in PCI-E
errors. The only reliable reset mechanism that exists on this
hardware is PCI Fundamental reset (warm reset). Since driving
this type of reset is architecture unique, this provides the
necessary hooks for architectures to add this support.
Signed-off-by: NBrian King <brking@linux.vnet.ibm.com>
Acked-by: NLinas Vepstas <linas@austin.ibm.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      f7bdd12d
  23. 28 4月, 2007 1 次提交
  25. 13 3月, 2007 2 次提交
    • E
      [PATCH] pci: Repair pci_save/restore_state so we can restore one save many times. · 9f35575d
      由 Eric W. Biederman 提交于 
      Because we do not reserve space for the pci-x and pci-e state in struct
pci dev we need to dynamically allocate it.  However because we need
to support restore being called multiple times after a single save
it is never safe to free the buffers we have allocated to hold the
state.

So this patch modifies the save routines to first check to see
if we have already allocated a state buffer before allocating
a new one.  Then the restore routines are modified to not free
the state after restoring it.  Simple and it fixes some subtle
error path handling bugs, that are hard to test for.
Signed-off-by: NEric W. Biederman <ebiederm@xmission.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
Acked-by: NAuke Kok <auke-jan.h.kok@intel.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      9f35575d
    • E
      [PATCH] msi: Safer state caching. · 392ee1e6
      由 Eric W. Biederman 提交于 
      There are two ways pci_save_state and pci_restore_state are used.  As
helper functions during suspend/resume, and as helper functions around
a hardware reset event.  When used as helper functions around a hardware
reset event there is no reason to believe the calls will be paired, nor
is there a good reason to believe that if we restore the msi state from
before the reset that it will match the current msi state.  Since arch
code may change the msi message without going through the driver, drivers
currently do not have enough information to even know when to call
pci_save_state to ensure they will have msi state in sync with the other
kernel irq reception data structures.

It turns out the solution is straight forward, cache the state in the
existing msi data structures (not the magic pci saved things) and
have the msi code update the cached state each time we write to the hardware.
This means we never need to read the hardware to figure out what the hardware
state should be.

By modifying the caching in this manner we get to remove our save_state
routines and only need to provide restore_state routines.

The only fields that were at all tricky to regenerate were the msi and msi-x
control registers and the way we regenerate them currently is a bit dependent
upon assumptions on how we use the allow msi registers to be configured and used
making the code a little bit brittle.  If we ever change what cases we allow
or how we configure the msi bits we can address the fragility then.
Signed-off-by: NEric W. Biederman <ebiederm@xmission.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
Acked-by: NAuke Kok <auke-jan.h.kok@intel.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      392ee1e6
  27. 10 3月, 2007 1 次提交
  29. 05 3月, 2007 1 次提交
    • E
      [PATCH] msi: sanely support hardware level msi disabling · f5f2b131
      由 Eric W. Biederman 提交于 
      In some cases when we are not using msi we need a way to ensure that the
hardware does not have an msi capability enabled.  Currently the code has been
calling disable_msi_mode to try and achieve that.  However disable_msi_mode
has several other side effects and is only available when msi support is
compiled in so it isn't really appropriate.

Instead this patch implements pci_msi_off which disables all msi and msix
capabilities unconditionally with no additional side effects.

pci_disable_device was redundantly clearing the bus master enable flag and
clearing the msi enable bit.  A device that is not allowed to perform bus
mastering operations cannot generate intx or msi interrupt messages as those
are essentially a special case of dma, and require bus mastering.  So the call
in pci_disable_device to disable msi capabilities was redundant.

quirk_pcie_pxh also called disable_msi_mode and is updated to use pci_msi_off.
Signed-off-by: NEric W. Biederman <ebiederm@xmission.com>
Cc: Michael Ellerman <michael@ellerman.id.au>
Cc: Paul Mackerras <paulus@samba.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      f5f2b131
  31. 17 2月, 2007 2 次提交
  33. 10 2月, 2007 1 次提交
    • T
      devres: device resource management · 9ac7849e
      由 Tejun Heo 提交于 
      Implement device resource management, in short, devres.  A device
driver can allocate arbirary size of devres data which is associated
with a release function.  On driver detach, release function is
invoked on the devres data, then, devres data is freed.

devreses are typed by associated release functions.  Some devreses are
better represented by single instance of the type while others need
multiple instances sharing the same release function.  Both usages are
supported.

devreses can be grouped using devres group such that a device driver
can easily release acquired resources halfway through initialization
or selectively release resources (e.g. resources for port 1 out of 4
ports).

This patch adds devres core including documentation and the following
managed interfaces.

* alloc/free	: devm_kzalloc(), devm_kzfree()
* IO region	: devm_request_region(), devm_release_region()
* IRQ		: devm_request_irq(), devm_free_irq()
* DMA		: dmam_alloc_coherent(), dmam_free_coherent(),
		  dmam_declare_coherent_memory(), dmam_pool_create(),
		  dmam_pool_destroy()
* PCI		: pcim_enable_device(), pcim_pin_device(), pci_is_managed()
* iomap		: devm_ioport_map(), devm_ioport_unmap(), devm_ioremap(),
		  devm_ioremap_nocache(), devm_iounmap(), pcim_iomap_table(),
		  pcim_iomap(), pcim_iounmap()
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>
      9ac7849e
  35. 08 2月, 2007 6 次提交