提交 · 498d8e236304a62a2774d7264bdff2c6e8102b5b · OpenHarmony / kernel_linux

09 7月, 2011 1 次提交

drivers/net: Omit check for multicast bit in netdev_for_each_mc_addr · 498d8e23

由 Tobias Klauser 提交于 7月 07, 2011

There is no need to check for the address being a multicast address in
the netdev_for_each_mc_addr loop, so remove it. This patch covers all
remaining network drivers still containing such a check.

Cc: Joe Perches <joe@perches.com>
Signed-off-by: NTobias Klauser <tklauser@distanz.ch>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

498d8e23

08 7月, 2011 5 次提交

skge/sky2: change config references to Marvell · 560040b8

由 stephen hemminger 提交于 7月 07, 2011

Change references to SysKonnect in Kconfig to Marvell since
SysKonnect was acquired by Marvell back in 2002.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

560040b8

sky2: version 1.29 · 4ec8f0ca

由 stephen hemminger 提交于 7月 07, 2011

Since new hardware chip support was added bump version.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

4ec8f0ca

sky2: support for new Optima chipsets (EXPERIMENTAL) · 4fb99cd6

由 stephen hemminger 提交于 7月 07, 2011

This is a backport from the vendor driver of support for the newer Optima
(Prime and 2) chipsets. It also includes some setup changes for the
current Optima chip as well. The code and comments intentionally
mirror the vendor sk98lin driver to allow for easier maintenance.

Although this adds support for new chip id's, these chip id's are not
used by any of the current PCI device id's listed in the driver.
The patch is just to get initial infrastructure in place to handle them
when they come.

I don't have access to any of this hardware to actually test it yet.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

4fb99cd6

sky2: use correct Inter Packet Gap at 10/100mbit · 8e11680f

由 stephen hemminger 提交于 7月 07, 2011

This is another fix picked out of the vendor driver. The IPG value
in the serial mode register is supposed to be programmed differently
at lower speeds.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

8e11680f

sky2: force receive checksum when using RSS on some hardware (v2) · aa5ca96c

由 stephen hemminger 提交于 7月 07, 2011

Found when reviewing the vendor driver. Apparently some chip versions
require receive checksumming to be enabled in order for RSS to work.

Also, if fix_features has to change some settings; put in message
in log in similar manner to netdev_fix_features.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

aa5ca96c

07 7月, 2011 9 次提交

sky2: use GFP_KERNEL allocations at device setup · 68ac3191

由 Eric Dumazet 提交于 7月 07, 2011

In process and sleep allowed context, favor GFP_KERNEL allocations over
GFP_ATOMIC ones.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

68ac3191

bnx2x: Add dcbnl notification · 3c878d47

由 Shmulik Ravid 提交于 7月 07, 2011

This patch adds a dcbnl notification to the bnx2x. The notification is
sent to user mode clients following a change in the dcb negotiated
parameters as resolved by the embedded DCBX stack. 
Signed-off-by: NShmulik Ravid <shmulikr@broadcom.com>
Signed-off-by: NEilon Greenstein <eilong@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

3c878d47

macvtap: macvtapTX zero-copy support · 97bc3633

由 Shirley Ma 提交于 7月 06, 2011

Only 128 bytes is copied, the rest of data is DMA mapped directly from
userspace.
Signed-off-by: NShirley Ma <xma@...ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

97bc3633

gianfar v2: code cleanups · 380b153c

由 Sebastian Poehn 提交于 7月 07, 2011

This patch:
# improves readability of some gianfar nfc code
Signed-off-by: NSebastian Poehn <sebastian.poehn@belden.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

380b153c

skge: update version · 5a9d6917

由 stephen hemminger 提交于 7月 06, 2011

Update version number, and take "New" off the config information
since old sk98lin has been gone for a couple years.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

5a9d6917

skge: make support for old Genesis chips optional · 57d6fa37

由 stephen hemminger 提交于 7月 06, 2011

The GENESIS boards are really old PCI-X boards that are rare.
Marvell has dropped support for this hardware and there is no reason
for most users to have to have this code.

Rather than riddling code with ifdef's make one macro and let
the compiler do the dead code elimination.  This saves about 15%
of the text size.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

57d6fa37

add pci-id for DGE-530T · c074304c

由 stephen hemminger 提交于 7月 06, 2011

See also: https://bugzilla.kernel.org/show_bug.cgi?id=38862

Reported-by: jameshenderson@ruggedcom.com
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

c074304c

skge: cleanup pci id table · 6f7d32f4

由 stephen hemminger 提交于 7月 06, 2011

The PCI table was using mix of defines for device id and hard coded
hex values. This patch change it to all hex values. It also adds
comments based on the names provided in the vendor driver table.

There is NO CHANGE to the actual resulting table.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

6f7d32f4

net: fix warning of versioncheck · fa917ff7

由 Shan Wei 提交于 7月 07, 2011

net-next-2.6/drivers/net/bnx2x/bnx2x_sp.c: 19 linux/version.h not needed.
net-next-2.6/drivers/net/caif/caif_hsi.c: 9 linux/version.h not needed.
Signed-off-by: NShan Wei <shanwei@cn.fujitsu.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

fa917ff7

06 7月, 2011 4 次提交

veth: Kill unused tx_dropped · 81b16ba2

由 Eric Dumazet 提交于 7月 06, 2011

Followup to commit f82528bc (Exclude duplicated checking for
iface-up) : We no longer need percpu tx_dropped field.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

81b16ba2

D
veth: Kill unused code label and code block. · 3600cdad
由 David S. Miller 提交于 7月 05, 2011
```
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
```
3600cdad

b44: Use pr_<level>_once and DRV_DESCRIPTION · 7329f0d5

由 Joe Perches 提交于 7月 05, 2011

Convert a printk with a static to pr_<level>_once
Add and use DRV_DESCRIPTION to reduce string duplication.
Remove now unused version.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

7329f0d5

vmxnet3: fix starving rx ring whenoc_skb kb fails · 5318d809

由 Shreyas Bhatewara 提交于 7月 05, 2011

If the rx ring is completely empty, then the device may never fire an rx
interrupt. Unfortunately, the rx interrupt is what triggers populating the
rx ring with fresh buffers, so this will cause networking to lock up.

This patch replenishes the skb in recv descriptor as soon as it is
peeled off while processing rx completions. If the skb/buffer
allocation fails, existing one is recycled and the packet in hand is
dropped. This way none of the RX desc is ever left empty, thus avoiding
starvation
Signed-off-by: NScott J. Goldman <scottjg@vmware.com>
Signed-off-by: NShreyas N Bhatewara <sbhatewara@vmware.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

5318d809

05 7月, 2011 19 次提交

bnx2x: Fix warning message during 57712/8727 initialization · 7d09926d