When we cancel 'async_pf_execute()', we should behave as if the work was
never scheduled in 'kvm_setup_async_pf()'.
Fixes a bug when we can't unload module because the vm wasn't destroyed.
Signed-off-by: NRadim Krčmář <rkrcmar@redhat.com>
Reviewed-by: NPaolo Bonzini <pbonzini@redhat.com>
Reviewed-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>

After commit a2766325, the error page is replaced by the
error code, it need not be released anymore

[ The patch has been compiling tested for powerpc ]
Signed-off-by: NXiao Guangrong <xiaoguangrong@linux.vnet.ibm.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

It is used to eliminate the overload of function call and cleanup
the code
Signed-off-by: NXiao Guangrong <xiaoguangrong@linux.vnet.ibm.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Currently, kvm allocates some pages and use them as error indicators,
it wastes memory and is not good for scalability

Base on Avi's suggestion, we use the error codes instead of these pages
to indicate the error conditions
Signed-off-by: NXiao Guangrong <xiaoguangrong@linux.vnet.ibm.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

In kvm_async_pf_wakeup_all, it uses bad_page to generate broadcast wakeup,
and uses put_page to release bad_page, the work depends on the fact that
bad_page is the normal page. But we will use the error code instead of
bad_page, so use kvm_release_page_clean to release the page which will
release the error code properly
Signed-off-by: NXiao Guangrong <xiaoguangrong@linux.vnet.ibm.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

In kvm_async_pf_wakeup_all(), we add a dummy apf to vcpu->async_pf.done
without holding vcpu->async_pf.lock, it will break if we are handling apfs
at this time.

Also use 'list_empty_careful()' instead of 'list_empty()'
Signed-off-by: NXiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Acked-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

If it's no need to inject async #PF to PV guest we can handle
more completed apfs at one time, so we can retry guest #PF
as early as possible
Signed-off-by: NXiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Acked-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Send async page fault to a PV guest if it accesses swapped out memory.
Guest will choose another task to run upon receiving the fault.

Allow async page fault injection only when guest is in user mode since
otherwise guest may be in non-sleepable context and will not be able
to reschedule.

Vcpu will be halted if guest will fault on the same page again or if
vcpu executes kernel code.
Acked-by: NRik van Riel <riel@redhat.com>
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Guest enables async PF vcpu functionality using this MSR.
Reviewed-by: NRik van Riel <riel@redhat.com>
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

When page is swapped in it is mapped into guest memory only after guest
tries to access it again and generate another fault. To save this fault
we can map it immediately since we know that guest is going to access
the page. Do it only when tdp is enabled for now. Shadow paging case is
more complicated. CR[034] and EFER registers should be switched before
doing mapping and then switched back.
Acked-by: NRik van Riel <riel@redhat.com>
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

If a guest accesses swapped out memory do not swap it in from vcpu thread
context. Schedule work to do swapping and put vcpu into halted state
instead.

Interrupts will still be delivered to the guest and if interrupt will
cause reschedule guest will continue to run another task.

[avi: remove call to get_user_pages_noio(), nacked by Linus; this
      makes everything synchrnous again]
Acked-by: NRik van Riel <riel@redhat.com>
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>