Modules: Intel8x0 driver

It seems that hardware requires some time to reset bus master registers.
We need to wait until ICH_RESETREGS bit is not released.

The suggestion and symptom was described by Mike Gorchak <lestat@i.com.ua>.
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: ICE1712 driver

See ALSA bug#1806 for details.
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: AC97 Codec

Removed the duplicated entry in lm4550_restbl.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: VIA82xx driver

Added dxs_support entry for FSC Amilo L7300.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

The following patch adds a 'test' ALC260 model specification to the
patch_realtek.c driver if CONFIG_SND_DEBUG is set.  This is similar to the
'test' ALC880 model in that it sets up mixer controls for almost everything
to make it easier for people to test their laptop/soundcard when working out
what pin widgets are connected to which real-world devices.

This patch assumes my previous patch (adding the second PCM to the ALC260)
has previously been applied since it uses infrastructure added by that
patch.

In developing this patch it was found that not all retasking pins accept all
the modes - in particular, some ignore the VREFxx variants.  The pin mode
control has therefore been tweaked to prevent this becoming a problem in
mixer applications.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

Jonathan Woithe <jwoithe@physics.adelaide.edu.au>

The following patch changes the initverbs associated with the output sum
widgets 0x08, 0x09 and 0x0a used with the fujitsu model in patch_realtek.c.
It is against alsa 1.0.11rc3.

Currently these widgets have their output muted, but a close reading of the
datasheet suggests that they don't actually have an output mute.  They have
an *input* mute for each of their two inputs and a single output gain. This
patch therefore activates the input mutes and zeros the output gain.  It has
not yet been tested but the above interpretation of the ALC260 datasheet
seems correct.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

The following patch against alsa 1.0.11rc3 creates a PCM device (pcm1c) for
the second ADC present on the ALC260 codec used by the hda driver.  It also
defines a new mixer control allowing the mode of retasking pins to be set;
this means a user can (for example) designate the headphone jack to be a
second input. With this patch in place it is possible to do 4 channel
recording on laptops equipped with an ALC260 codec assuming both a stereo
line-in jack is provided in addition to a headphone jack.

Mixer controls are provided to allow the headphone jack to be switched as
an input.  In addition, an (input only) mode control is configured for
the line-in jack to allow a bias voltage to be requested (VREF80 or VREF50)
so headsets based on condensor microphones have a chance of working.

This patch has been tested on a Fujitsu S7020 laptop and as such these
features are currently only configured for the 'fujitsu' model.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: AC97 Codec

Added a codec patch for LM4550.  It sets up a static volume resolution
table.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: AC97 Codec

Added the support of static resolution table support for codecs
that the driver cannot probe the volume resolution properly.

The table pointer should be set in each codec patch.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: BT87x driver

- added 0x107d:0x6606 to whitelist
- print also the pci device ID for developers when model is not known
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: ICE1712 driver

Change the value written to hardware configuration register of envy24 chip
in the case of Terratec DMX6fire to restrict the active ADCs & DACs to 6.

Also add the dxr_enable module option to eventually leave the old behaviour
when user requests.
Signed-off-by: NAlan Horstmann <gineera@aspect135.co.uk>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: I2C cs8427,ICE1712 driver

See ALSA bug#1785 for more details.
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: YMFPCI driver

Added rear_swap module option / kernel parameter to configure the rear
channel swapping. Default value is enable to make the AC3 passthrough
working, but analog only users might revert the previous behaviour.
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Semaphore to mutex conversion.

The conversion was generated via scripts, and the result was validated
automatically via a script as well.
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: au88x0 driver

Fixed the structures for equalizer.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: au88x0 driver

Fix the driver codes to run on 64bit architectures.
The patch taken from ALSA BTS bug#1047.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: ICE1712 driver

Added the support of Prodigy-7.1LT board.
The patch taken from ALSA BTS bug#1090.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: YMFPCI driver

The routing of the effect 2/3 channels to the digital output is the
opposite of the rear analog output (left/right swapped).

We make the order correct for the digital output (which will make the
analog rear have the channels swapped) to make AC3 output work.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: Documentation,HDA Intel driver

Added single_cmd module option for debugging in the case CORB/RIRB
doesn't work well (e.g. due to wrong irq routings).
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: Intel8x0 driver

Fix the detection of tertriary codec on SIS7012, including clean-ups
of relevant codes.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: ENS1370/1+ driver

Fix resume of ens1370 driver.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: Digigram PCXHR driver

Suppress debug messages.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

Fixed typos in alc882 model table.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

This little patch add the model for the motherboard K8N51 from Gigabyte
to the known models of ALC boards.
Signed-off-by: NArnaud Patard <apatard@mandriva.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

* Fix init sequence so manually retaskable jacks don't get added to
  the line_out list.
* Update intel mobo config defaults to specify surround outputs
  as line outs rather than speakers.
Signed-off-by: NMatt Porter <mporter@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: Documentation,Intel8x0 driver

Added MCP51 PCI ID to intel8x0 driver.
Also, updated the supported chips in documentation.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

Fixed the wrong widget id for line-2 selector in the init verb
of ALC260.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

Fix max_channels computation for STAC92xx codecs in the case only
HP pin without line-out pins is detected in the default pin config.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: VIA82xx driver

Added the dxs entry for P4M800/VIA8237R,
reported by OGAWA Hirofumi <hirofumi@mail.parknet.co.jp>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

Adds support for the SigmaTel STAC927x HDA codec family.
Signed-off-by: NMatt Porter <mporter@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

Add SigmaTel HDA support for the Intel D975XBK motherboard.
Signed-off-by: NMatt Porter <mporter@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

This adds support for Agere's variant of Si3054/5 based HDA modem.
Signed-off-by: NSasha Khapyorsky <sashak@alsa-project.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: VIA82xx driver

Add dxs entry for a FSC board.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: Digigram PCXHR driver

sound/pci/pcxhr/pcxhr.c: In function 'pcxhr_update_r_buffer':
sound/pci/pcxhr/pcxhr.c:460: warning: unsigned int format, different type arg (arg 7)
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: RME9652 driver

sound/pci/rme9652/hdspm.c: In function 'snd_hdspm_preallocate_memory':
sound/pci/rme9652/hdspm.c:3327: warning: int format, different type arg (arg 4)
sound/pci/rme9652/hdspm.c:3331: warning: int format, different type arg (arg 4)
sound/pci/rme9652/hdspm.c: In function 'snd_hdspm_create':
sound/pci/rme9652/hdspm.c:3513: warning: int format, different type arg (arg 4)
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: CS46xx driver

Reported by <dcb314@hotmail.com> in
http://bugzilla.kernel.org/show_bug.cgi?id=5903Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: au88x0 driver

Fixed an uninitialized variable.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: VIA82xx driver

Added the dxs_support entry for EpoX 9HEAI.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: HDA Codec driver

Added the missing 'Capture Switch' control for Sigmatel STAC92xx codecs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: Intel8x0 driver

This patch adds a quirk entry for the Dell Optiplex GX270, on which
the volume is set by the headphone control, not the master control.
Signed-off-by: NChris Ball <cjb@mrao.cam.ac.uk>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>