Uses of RCU for dynamically changeable NMI handlers need to use the new
rcu_dereference() and rcu_assign_pointer() facilities.  This change makes
it clear that these uses are safe from a memory-barrier viewpoint, but the
main purpose is to document exactly what operations are being protected by
RCU.  This has been tested on x86 and x86-64, which are the only
architectures affected by this change.

Signed-off-by: <paulmck@us.ibm.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch adds a notify to the die_nmi notify that the system is about to
be taken down.  If the notify is handled with a NOTIFY_STOP return, the
system is given a new lease on life.

We also change the nmi watchdog to carry on if die_nmi returns.

This give debug code a chance to a) catch watchdog timeouts and b) possibly
allow the system to continue, realizing that the time out may be due to
debugger activities such as single stepping which is usually done with
"other" cpus held.

Signed-off-by: George Anzinger<george@mvista.com>
Cc: Keith Owens <kaos@ocs.com.au>
Signed-off-by: NGeorge Anzinger <george@mvista.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Privilege checking cleanup.  Originally, these diffs were much greater, but
recent cleanups in Linux have already done much of the cleanup.  I added
some explanatory comments in places where the reasoning behind certain
tests is rather subtle.

Also, in traps.c, we can skip the user_mode check in handle_BUG().  The
reason is, there are only two call chains - one via die_if_kernel() and one
via do_page_fault(), both entering from die().  Both of these paths already
ensure that a kernel mode failure has happened.  Also, the original check
here, if (user_mode(regs)) was insufficient anyways, since it would not
rule out BUG faults from V8086 mode execution.

Saving the %ss segment in show_regs() rather than assuming a fixed value
also gives better information about the current kernel state in the
register dump.
Signed-off-by: NZachary Amsden <zach@vmware.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

i386 inline assembler cleanup.

This change encapsulates descriptor and task register management.  Also,
it is possible to improve assembler generation in two cases; savesegment
may store the value in a register instead of a memory location, which
allows GCC to optimize stack variables into registers, and MOV MEM, SEG
is always a 16-bit write to memory, making the casting in math-emu
unnecessary.
Signed-off-by: NZachary Amsden <zach@vmware.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

i386 floating-point exception handling has a bug that can cause error
code 0 to be sent instead of the proper code during signal delivery.

This is caused by unconditionally checking the IS and c1 bits from the
FPU status word when they are not always relevant.  The IS bit tells
whether an exception is a stack fault and is only relevant when the
exception is IE (invalid operation.) The C1 bit determines whether a
stack fault is overflow or underflow and is only relevant when IS and IE
are set.
Signed-off-by: NChuck Ebbert <76306.1226@compuserve.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NAlexey Dobriyan <adobriyan@mail.ru>
Signed-off-by: NDomen Puncer <domen@coderock.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

If we are faulting in kernel it is quite possible this will lead to a
panic.  Save trap number, cr2 (in case of page fault) and error_code in the
current thread (these fields already exist for signal delivery but are not
used here).

This helps later kdump crash analyzing from user-space (a script has been
submitted to dig this info out in gdb).
Signed-off-by: NAlexander Nyberg <alexn@telia.com>
Cc: <fastboot@lists.osdl.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Makes kexec_crashdump() take a pt_regs * as an argument.  This allows to
get exact register state at the point of the crash.  If we come from direct
panic assertion NULL will be passed and the current registers saved before
crashdump.

This hooks into two places:
die(): check the conditions under which we will panic when calling
do_exit and go there directly with the pt_regs that caused the fatal
fault.

die_nmi(): If we receive an NMI lockup while in the kernel use the
pt_regs and go directly to crash_kexec(). We're probably nested up badly
at this point so this might be the only chance to escape with proper
information.
Signed-off-by: NAlexander Nyberg <alexn@telia.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

(The i386 CPU hotplug patch provides infrastructure for some work which Pavel
is doing as well as for ACPI S3 (suspend-to-RAM) work which Li Shaohua
<shaohua.li@intel.com> is doing)

The following provides i386 architecture support for safely unregistering and
registering processors during runtime, updated for the current -mm tree.  In
order to avoid dumping cpu hotplug code into kernel/irq/* i dropped the
cpu_online check in do_IRQ() by modifying fixup_irqs().  The difference being
that on cpu offline, fixup_irqs() is called before we clear the cpu from
cpu_online_map and a long delay in order to ensure that we never have any
queued external interrupts on the APICs.  There are additional changes to s390
and ppc64 to account for this change.

1) Add CONFIG_HOTPLUG_CPU
2) disable local APIC timer on dead cpus.
3) Disable preempt around irq balancing to prevent CPUs going down.
4) Print irq stats for all possible cpus.
5) Debugging check for interrupts on offline cpus.
6) Hacky fixup_irqs() to redirect irqs when cpus go off/online.
7) play_dead() for offline cpus to spin inside.
8) Handle offline cpus set in flush_tlb_others().
9) Grab lock earlier in smp_call_function() to prevent CPUs going down.
10) Implement __cpu_disable() and __cpu_die().
11) Enable local interrupts in cpu_enable() after fixup_irqs()
12) Don't fiddle with NMI on dead cpu, but leave intact on other cpus.
13) Program IRQ affinity whilst cpu is still in cpu_online_map on offline.
Signed-off-by: NZwane Mwaikambo <zwane@linuxpower.ca>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Use the user_mode macro where it's possible.
Signed-off-by: NVincent Hanquez <vincent.hanquez@cl.cam.ac.uk>
Cc: Ian Pratt <m+Ian.Pratt@cl.cam.ac.uk>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Make use of the 2 new macro set_debugreg and get_debugreg.
Signed-off-by: NVincent Hanquez <vincent.hanquez@cl.cam.ac.uk>
Cc: Ian Pratt <m+Ian.Pratt@cl.cam.ac.uk>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

* EXPORT_SYMBOL's moved to other files
* #include <linux/config.h>, <linux/module.h> where needed
* #include's in i386_ksyms.c cleaned up
* After copy-paste, redundant due to Makefiles rules preprocessor directives
  removed:

	#ifdef CONFIG_FOO
	EXPORT_SYMBOL(foo);
	#endif

	obj-$(CONFIG_FOO) += foo.o

* Tiny reformat to fit in 80 columns
Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch implements a number of smp_processor_id() cleanup ideas that
Arjan van de Ven and I came up with.

The previous __smp_processor_id/_smp_processor_id/smp_processor_id API
spaghetti was hard to follow both on the implementational and on the
usage side.

Some of the complexity arose from picking wrong names, some of the
complexity comes from the fact that not all architectures defined
__smp_processor_id.

In the new code, there are two externally visible symbols:

 - smp_processor_id(): debug variant.

 - raw_smp_processor_id(): nondebug variant. Replaces all existing
   uses of _smp_processor_id() and __smp_processor_id(). Defined
   by every SMP architecture in include/asm-*/smp.h.

There is one new internal symbol, dependent on DEBUG_PREEMPT:

 - debug_smp_processor_id(): internal debug variant, mapped to
                             smp_processor_id().

Also, i moved debug_smp_processor_id() from lib/kernel_lock.c into a new
lib/smp_processor_id.c file.  All related comments got updated and/or
clarified.

I have build/boot tested the following 8 .config combinations on x86:

 {SMP,UP} x {PREEMPT,!PREEMPT} x {DEBUG_PREEMPT,!DEBUG_PREEMPT}

I have also build/boot tested x64 on UP/PREEMPT/DEBUG_PREEMPT.  (Other
architectures are untested, but should work just fine.)
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NArjan van de Ven <arjan@infradead.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

do_debug() and do_int3() return void.

This patch fixes the CONFIG_KPROBES variant of do_int3() to return void too
and adjusts entry.S accordingly.
Signed-off-by: NStas Sergeev <stsp@aknet.ru>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This makes a trap on the 'iret' that returns us to user space
cause a nice clean SIGSEGV, instead of just a hard (and silent)
exit.

That way a debugger can actually try to see what happened, and
we also properly notify everybody who might be interested about
us being gone.

This loses the error code, but tells the debugger what happened
with ILL_BADSTK in the siginfo.

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!