mtd: nand_wait: warn if the nand is busy on exit

This patch allow to detect buggy driver/hardware with
bad RnB (dev_ready) management or when timeout occurs in polling mode.

This works when dev_ready is set or not set.
There are 2 methods to wait for an erase/program command completion:

1. Wait until nand RnB pin goes high (that's what chip->dev_ready usually does)
2. Poll the device: send a status (0x70) command and read status byte in a loop
   until bit NAND_STATUS_READY is set

In all cases, you should send a status command after completion, to check if
the operation was successful. And if the operation completed, the status should
have bit NAND_STATUS_READY set.
Signed-off-by: NMatthieu CASTET <matthieu.castet@parrot.com>
Signed-off-by: NArtem Bityutskiy <artem.bityutskiy@linux.intel.com>

drivers/mtd/nand/nand_base.c

@@ -865,6 +865,8 @@ static int nand_wait(struct mtd_info *mtd, struct nand_chip *chip)
 	led_trigger_event(nand_led_trigger, LED_OFF);
 
 	status = (int)chip->read_byte(mtd);
+	/* This can happen if in case of timeout or buggy dev_ready */
+	WARN_ON(!(status & NAND_STATUS_READY));
 	return status;
 }