ARM: ux500: Remove unused 'data_width' attributes from UART DMA configs

DMA configuration data is now allocated in the UART driver, so these
are just ignored.
Signed-off-by: NLee Jones <lee.jones@linaro.org>
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>

arch/arm/mach-ux500/board-mop500.c

@@ -504,48 +504,36 @@ static struct stedma40_chan_cfg uart0_dma_cfg_rx = {
 	.mode = STEDMA40_MODE_LOGICAL,
 	.dir = STEDMA40_PERIPH_TO_MEM,
 	.dev_type = DB8500_DMA_DEV13_UART0,
-	.src_info.data_width = STEDMA40_BYTE_WIDTH,
-	.dst_info.data_width = STEDMA40_BYTE_WIDTH,
 };
 
 static struct stedma40_chan_cfg uart0_dma_cfg_tx = {
 	.mode = STEDMA40_MODE_LOGICAL,
 	.dir = STEDMA40_MEM_TO_PERIPH,
 	.dev_type = DB8500_DMA_DEV13_UART0,
-	.src_info.data_width = STEDMA40_BYTE_WIDTH,
-	.dst_info.data_width = STEDMA40_BYTE_WIDTH,
 };
 
 static struct stedma40_chan_cfg uart1_dma_cfg_rx = {
 	.mode = STEDMA40_MODE_LOGICAL,
 	.dir = STEDMA40_PERIPH_TO_MEM,
 	.dev_type = DB8500_DMA_DEV12_UART1,
-	.src_info.data_width = STEDMA40_BYTE_WIDTH,
-	.dst_info.data_width = STEDMA40_BYTE_WIDTH,
 };
 
 static struct stedma40_chan_cfg uart1_dma_cfg_tx = {
 	.mode = STEDMA40_MODE_LOGICAL,
 	.dir = STEDMA40_MEM_TO_PERIPH,
 	.dev_type = DB8500_DMA_DEV12_UART1,
-	.src_info.data_width = STEDMA40_BYTE_WIDTH,
-	.dst_info.data_width = STEDMA40_BYTE_WIDTH,
 };
 
 static struct stedma40_chan_cfg uart2_dma_cfg_rx = {
 	.mode = STEDMA40_MODE_LOGICAL,
 	.dir = STEDMA40_PERIPH_TO_MEM,
 	.dev_type = DB8500_DMA_DEV11_UART2,
-	.src_info.data_width = STEDMA40_BYTE_WIDTH,
-	.dst_info.data_width = STEDMA40_BYTE_WIDTH,
 };
 
 static struct stedma40_chan_cfg uart2_dma_cfg_tx = {
 	.mode = STEDMA40_MODE_LOGICAL,
 	.dir = STEDMA40_MEM_TO_PERIPH,
 	.dev_type = DB8500_DMA_DEV11_UART2,
-	.src_info.data_width = STEDMA40_BYTE_WIDTH,
-	.dst_info.data_width = STEDMA40_BYTE_WIDTH,
 };
 #endif