ethernet: sfc: Add Kconfig entry for vendor Solarflare

Since commit

  5a6681e2 ("sfc: separate out SFC4000 ("Falcon") support into new sfc-falcon driver")

there are two drivers for Solarflare devices, but both still show up
directly beneath "Ethernet driver support" in the Kconfig. Follow the
pattern of other vendors and group them beneath an own vendor Kconfig
entry for Solarflare.

Cc: Edward Cree <ecree@solarflare.com>
Signed-off-by: NTobias Klauser <tklauser@distanz.ch>
Acked-by: NEdward Cree <ecree@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/Kconfig

@@ -166,7 +166,6 @@ source "drivers/net/ethernet/seeq/Kconfig"
 source "drivers/net/ethernet/silan/Kconfig"
 source "drivers/net/ethernet/sis/Kconfig"
 source "drivers/net/ethernet/sfc/Kconfig"
-source "drivers/net/ethernet/sfc/falcon/Kconfig"
 source "drivers/net/ethernet/sgi/Kconfig"
 source "drivers/net/ethernet/smsc/Kconfig"
 source "drivers/net/ethernet/stmicro/Kconfig"

drivers/net/ethernet/sfc/Kconfig

+#
+# Solarflare device configuration
+#
+
+config NET_VENDOR_SOLARFLARE
+	bool "Solarflare devices"
+	default y
+	---help---
+	  If you have a network (Ethernet) card belonging to this class, say Y.
+
+	  Note that the answer to this question doesn't directly affect the
+	  kernel: saying N will just cause the configurator to skip all
+	  the questions about Solarflare devices. If you say Y, you will be asked
+	  for your specific card in the following questions.
+
+if NET_VENDOR_SOLARFLARE
+
 config SFC
 	tristate "Solarflare SFC9000/SFC9100-family support"
 	depends on PCI
@@ -44,3 +61,7 @@ config SFC_MCDI_LOGGING
 	  Driver-Interface) commands and responses, allowing debugging of
 	  driver/firmware interaction.  The tracing is actually enabled by
 	  a sysfs file 'mcdi_logging' under the PCI device.
+
+source "drivers/net/ethernet/sfc/falcon/Kconfig"
+
+endif # NET_VENDOR_SOLARFLARE