[ARM] S3C: Remove unused CONFIG_DEBUG_S3C_PORT

Remove the unused CONFIG_DEBUG_S3C_PORT as we currently only have
support for using the S3C UARTs via the low-level debug code.
Signed-off-by: NBen Dooks <ben-linux@fluff.org>

arch/arm/Kconfig.debug

@@ -99,14 +99,6 @@ config DEBUG_CLPS711X_UART2
 	  output to the second serial port on these devices.  Saying N will
 	  cause the debug messages to appear on the first serial port.
 
-config DEBUG_S3C_PORT
-	depends on DEBUG_LL && PLAT_S3C
-	bool "Kernel low-level debugging messages via S3C UART"
-	help
-	  Say Y here if you want debug print routines to go to one of the
-	  S3C internal UARTs. The chosen UART must have been configured
-	  before it is used.
-
 config DEBUG_S3C_UART
 	depends on PLAT_S3C
 	int "S3C UART to use for low-level debug"

arch/arm/configs/s3c2410_defconfig

@@ -2298,7 +2298,6 @@ CONFIG_DEBUG_ERRORS=y
 # CONFIG_DEBUG_STACK_USAGE is not set
 CONFIG_DEBUG_LL=y
 # CONFIG_DEBUG_ICEDCC is not set
-CONFIG_DEBUG_S3C_PORT=y
 CONFIG_DEBUG_S3C_UART=0
 
 #

arch/arm/configs/s3c6400_defconfig

@@ -816,7 +816,6 @@ CONFIG_DEBUG_ERRORS=y
 # CONFIG_DEBUG_STACK_USAGE is not set
 CONFIG_DEBUG_LL=y
 # CONFIG_DEBUG_ICEDCC is not set
-CONFIG_DEBUG_S3C_PORT=y
 CONFIG_DEBUG_S3C_UART=0
 
 #

arch/arm/configs/tct_hammer_defconfig

@@ -857,7 +857,6 @@ CONFIG_DEBUG_ERRORS=y
 # CONFIG_DEBUG_STACK_USAGE is not set
 CONFIG_DEBUG_LL=y
 # CONFIG_DEBUG_ICEDCC is not set
-# CONFIG_DEBUG_S3C_PORT is not set
 CONFIG_DEBUG_S3C_UART=0
 
 #