ARM: dts: omap5: add sata node

Add support for sata.

[Roger Q] Clean up.

CC: Benoit Cousson <bcousson@baylibre.com>
CC: Tony Lindgren <tony@atomide.com>
Signed-off-by: NBalaji T K <balajitk@ti.com>
Signed-off-by: NRoger Quadros <rogerq@ti.com>
Signed-off-by: NTony Lindgren <tony@atomide.com>

arch/arm/boot/dts/omap5.dtsi

@@ -875,6 +875,46 @@
 
 			#thermal-sensor-cells = <1>;
 		};
+
+		omap_control_sata: control-phy@4a002374 {
+			compatible = "ti,control-phy-pipe3";
+			reg = <0x4a002374 0x4>;
+			reg-names = "power";
+			clocks = <&sys_clkin>;
+			clock-names = "sysclk";
+		};
+
+		/* OCP2SCP3 */
+		ocp2scp@4a090000 {
+			compatible = "ti,omap-ocp2scp";
+			#address-cells = <1>;
+			#size-cells = <1>;
+			reg = <0x4a090000 0x20>;
+			ranges;
+			ti,hwmods = "ocp2scp3";
+			sata_phy: phy@4a096000 {
+				compatible = "ti,phy-pipe3-sata";
+				reg = <0x4A096000 0x80>, /* phy_rx */
+				      <0x4A096400 0x64>, /* phy_tx */
+				      <0x4A096800 0x40>; /* pll_ctrl */
+				reg-names = "phy_rx", "phy_tx", "pll_ctrl";
+				ctrl-module = <&omap_control_sata>;
+				clocks = <&sys_clkin>;
+				clock-names = "sysclk";
+				#phy-cells = <0>;
+			};
+		};
+
+		sata: sata@4a141100 {
+			compatible = "snps,dwc-ahci";
+			reg = <0x4a140000 0x1100>, <0x4a141100 0x7>;
+			interrupts = <GIC_SPI 54 IRQ_TYPE_LEVEL_HIGH>;
+			phys = <&sata_phy>;
+			phy-names = "sata-phy";
+			clocks = <&sata_ref_clk>;
+			ti,hwmods = "sata";
+		};
+
 	};
 };