bnx2x: 57840 non-external loopback test fail on 1G

when 1G-optic module was plugged in, internal loopback test failed because the
driver used to check the optic module (with no need), and for 1G optic module,
the link speed was forced down to 1G, while the XMAC (10G MAC) was enabled.
This patch avoid accessing optic module in case internal loopback was selected,
and update the link speed in case 1G optic module was detected during init
stage.
Signed-off-by: NYaniv Rosner <yanivr@broadcom.com>
Signed-off-by: NEilon Greenstein <eilong@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c

@@ -4523,10 +4523,14 @@ static void bnx2x_warpcore_config_init(struct bnx2x_phy *phy,
 			 * enabled transmitter to avoid current leakage in case
 			 * no module is connected
 			 */
-			if (bnx2x_is_sfp_module_plugged(phy, params))
-				bnx2x_sfp_module_detection(phy, params);
-			else
-				bnx2x_sfp_e3_set_transmitter(params, phy, 1);
+			if ((params->loopback_mode == LOOPBACK_NONE) ||
+			    (params->loopback_mode == LOOPBACK_EXT)) {
+				if (bnx2x_is_sfp_module_plugged(phy, params))
+					bnx2x_sfp_module_detection(phy, params);
+				else
+					bnx2x_sfp_e3_set_transmitter(params,
+								     phy, 1);
+			}
 
 			bnx2x_warpcore_config_sfi(phy, params);
 			break;
@@ -6528,6 +6532,11 @@ static int bnx2x_link_initialize(struct link_params *params,
 			params->phy[INT_PHY].config_init(phy, params, vars);
 	}
 
+	/* Re-read this value in case it was changed inside config_init due to
+	 * limitations of optic module
+	 */
+	vars->line_speed = params->phy[INT_PHY].req_line_speed;
+
 	/* Init external phy*/
 	if (non_ext_phy) {
 		if (params->phy[INT_PHY].supported &