This pull request contains Broadcom ARM-based SoC Device Tree changes for 4.11,
please pull the following changes:

- Rafal enables the UART by default on all BCM5301x, BCM4708, BCM4709 since
  every device found out there has it enabled by default. He also fixes the
  LED definitions for the Luxul XWR-3100 device, enables USB controllers and
  their respective PHY devices, specifies the correct GPIO to power on USB
  HUBs, adds the additional RAM bank for somes devices, and finally sets the
  correct 5Ghz frequency limits on the Netgear R8000

- Jon does a number of Norsthar Plus SoC cleanups, fixes NAND partitions unit
  addresses, adds QSPI support to a bunch of boards, adds Ethernet switch ports
  to the BCM958625K reference board, enables 3rd Ethernet MAC instance to
  relevant DTSes, enables Ethernet on the XMC board, and finally adds SD/MMC
  support to the XMC board

- Boris adds the Video Encoder nodes to the Raspberry Pi DTS include files
  ands enables it on the relevant boards

- Dan adds support for two new Luxul devices: XAP-1410 and XWR-1200, both
  BCM47081 based SoCs

* tag 'arm-soc/for-4.11/devicetree' of http://github.com/Broadcom/stblinux:
  ARM: dts: bcm283x: Enable the VEC IP on all RaspberryPi boards
  ARM: dts: bcm283x: Add VEC node in bcm283x.dtsi
  ARM: dts: BCM5301X: Add DT for Luxul XWR-1200
  ARM: dts: BCM5301X: Add DT for Luxul XAP-1410
  ARM: dts: BCM5301X: Set 5 GHz wireless frequency limits on Netgear R8000
  ARM: dts: NSP: Add SD/MMC support
  ARM: dts: NSP: Add Ethernet to NSP XMC
  ARM: dts: NSP: Add and enable amac2
  ARM: dts: NSP: Add BCM958625K switch ports
  ARM: dts: NSP: Add QSPI support to missing boards
  ARM: dts: NSP: Correct NAND partition unit address
  ARM: dts: NSP: DT Clean-ups
  ARM: dts: BCM53573: Specify USB ports of on-SoC controllers
  ARM: dts: BCM5301X: Specify all RAM by including an extra block
  ARM: dts: BCM5301X: Set GPIO enabling USB power on Netgear R7000
  ARM: dts: BCM5301X: Specify USB controllers in DT
  ARM: dts: BCM5301X: Fix LAN LED labels for Luxul XWR-3100
  ARM: dts: BCM5301X: Enable UART by default for BCM4708(1), BCM4709(4) & BCM53012
Signed-off-by: NOlof Johansson <olof@lixom.net>