1. 15 12月, 2011 2 次提交
    • J
      [SCSI] lpfc 8.3.28: SLI fixes and added SLI4 support · ff78d8f9
      James Smart 提交于
      Adapter (SLI) interface fixes:
      
      - Modify WQ handling to use entry_repost (CR 123981)
      - Fix for ABTS.  Do not free original IOCB whenever ABTS fails. (CR 115829)
      - Check board for FCoE before reading FCoE paramaters (CR124731)
      - Add support for SLI4 FC Loop mode (CR 124721)
      - Add support for resource count changes during fw reset. (CR 125888, 125675)
      - Increase CQE count from 256 to 1024. (CR 126149)
      Signed-off-by: NAlex Iannicelli <alex.iannicelli@emulex.com>
      Signed-off-by: NJames Smart <james.smart@emulex.com>
      Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>
      ff78d8f9
    • J
      [SCSI] lpfc 8.3.28: Miscellaneous fixes in sysfs and mgmt interfaces · 026abb87
      James Smart 提交于
      Miscellaneous fixes in sysfs and mgmt interfaces:
      
      - Added SLI4 INTF_TYPE and SLI_FAMILY as sub-field to the fwrev sysfs
        attribute (CR 124103)
      - Added a sysfs attribute "protocol" to report SLI4 port link protocol
        type (CR 124102)
      - Increment mix-and-match minor number by 1 for added "protocol" sysfs
        attribute. (124102)
      - Move the link speed check into the generic sli3/sli4 code
        path. (CR 124185, 124122)
      - Deleted check for inExtWLen (CR 122523)
      - Add the word "offline" to message 2889 (CR 124385)
      - Conditionalize the firmware upgrade/downgrade so that it is only
        attempted for SLI4 type 2 boards (CR 124406)
      - Return an error if the mbox sysfs is called. (CR 124210)
      - When port_state is less than LPFC_VPORT_READY, report
        FC_PORTSTATE_BYPASSED (CR 120018)
      - Added driver support for performing persistent linkdown based on
        configure region 23 (CR 124534)
      - Added restore state and error log when sysfs board_mode attribute
        access failed (CR 124158)
      - Added support for SLI4_CONFIG non-embedded COMN_GET_CNTL_ADDL_ATTR
        pass-through (CR 124466)
      - Rejecting un-supported multi-buffer mailbox commands (CR 124771)
      - Byte swap the extended data request and response data for extended
        mailbox data (CR 125081)
      Signed-off-by: NAlex Iannicelli <alex.iannicelli@emulex.com>
      Signed-off-by: NJames Smart <james.smart@emulex.com>
      Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>
      026abb87
  2. 01 11月, 2011 2 次提交
  3. 17 10月, 2011 6 次提交
  4. 29 8月, 2011 4 次提交
  5. 27 7月, 2011 8 次提交
  6. 21 7月, 2011 1 次提交
    • P
      treewide: fix potentially dangerous trailing ';' in #defined values/expressions · 497888cf
      Phil Carmody 提交于
      All these are instances of
        #define NAME value;
      or
        #define NAME(params_opt) value;
      
      These of course fail to build when used in contexts like
        if(foo $OP NAME)
        while(bar $OP NAME)
      and may silently generate the wrong code in contexts such as
        foo = NAME + 1;    /* foo = value; + 1; */
        bar = NAME - 1;    /* bar = value; - 1; */
        baz = NAME & quux; /* baz = value; & quux; */
      
      Reported on comp.lang.c,
      Message-ID: <ab0d55fe-25e5-482b-811e-c475aa6065c3@c29g2000yqd.googlegroups.com>
      Initial analysis of the dangers provided by Keith Thompson in that thread.
      
      There are many more instances of more complicated macros having unnecessary
      trailing semicolons, but this pile seems to be all of the cases of simple
      values suffering from the problem. (Thus things that are likely to be found
      in one of the contexts above, more complicated ones aren't.)
      Signed-off-by: NPhil Carmody <ext-phil.2.carmody@nokia.com>
      Signed-off-by: NJiri Kosina <jkosina@suse.cz>
      497888cf
  7. 29 6月, 2011 1 次提交
  8. 27 5月, 2011 6 次提交
  9. 10 5月, 2011 1 次提交
  10. 02 5月, 2011 5 次提交
  11. 01 5月, 2011 1 次提交
  12. 10 4月, 2011 1 次提交
  13. 31 3月, 2011 1 次提交
  14. 24 3月, 2011 1 次提交