Check bit 2 of Word 53 for Word 88 validity before using Word 88 to
determine UDMA mask.  Note that the original xfer mask implementation
using ata_get_mode_mask() didn't consider bit 2 of Word 53.  This
patch introduces different (correct) behavior.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

ata_bus_probe() didn't set classes[] properly for port disabled case
of ->phy_reset() compatibility path.  This patch moves classes[]
initialization and normalization out of ->probe_reset block such that
it applies to both ->probe_reset and ->phy_reset paths.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Turn on AHCI_CMD_PREFETCH for PACKET commands.  This hints the
controller that it can prefetch the CDB and the PRD entries.  This
patch is originally from Jeff Garzik.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

sil24 softreset timeout was > 100ms (100 loops with msleep(1)), which
turned out to be too short for some devices (ASI ARAID99 2000).  This
patch converts sil24 softreset waiting loop to use proper timeout
condition and lengthen the timeout to ATA_TMOUT_BOOT secs and check
interval to 100ms.  Chisato Yamauchi discovered the problem and
supplied initial patch.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Cc: Chisato Yamauchi <cyamauch@plamo.linet.gr.jp>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

sata_sil24 softreset routine used to check sata_dev_present() after
SRST is complete in the hope that SRST may do some good even when
SStatus reports no device.  This is okay as long as SRST timeout is
short (> 100ms in the current code) but it seems that not all SATA
devices are happy with short SRST timeout.

This patch makes softreset exit early without performing actual SRST
if SStatus reports no device in preparation for lengthening SRST
timeout.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Fix NULL pointer dereference detected by the Coverity checker.  Kill
dev -> pdev -> dev conversion while at it.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Cc: Adrian Bunk <bunk@stusta.de>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

ata_bus_probe() didn't initialize classes[] properly with
ATA_DEV_UNKNOWN.  As ->probe_reset() is allowed to leave @classes
alone when no device is present, this results in garbage class values.
ATM, the only affected driver is ata_piix.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Cc: Jiri Slaby <jirislaby@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Preceding xfer_mask changes make the following functions unused.

  ata_pio_modes(), base_from_shift(), ata_pr_blacklisted(), fgb()

Kill them.  Also, as xfer_mode_str[] is now only used by
ata_mode_string(), move it into the function.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Use xfer_mask helpers to determine transfer mode.  This rewrite also
makes transfer mode determination done before any actual
configuration.  This patch doesn't result in any functional changes.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Rewrite hardcoded xfer_mode string determination in ata_dev_set_mode()
using xfer_mask helpers.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Replace quick & dirty max transfer mode determination in
ata_dev_configure() with ata_id_xfermask().  While at it, rename
xfer_modes variable to xfer_mask and make it unsigned int for
consistency.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Add ata_pack_xfermask(), ata_xfer_mask2mode(), ata_xfer_mode2mask(),
ata_xfer_mode2shift() and ata_id_xfermask().  These functions will be
used by following patches to simplify xfer_mask handling.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Add ATA_BITS_*, ATA_MASK_* macros and reorder xfer_mask fields such
that higher transfer mode is placed at higher order bit.  As thie
reordering breaks ata_mode_string(), this patch also rewrites
ata_mode_string().
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Rename ATA_FLAG_FLUSH_PIO_TASK to ATA_FLAG_FLUSH_PORT_TASK.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Kill unused pio_task and packet_task.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Make pio_task and atapi_packet_task use port_task.
atapi_packet_task() is moved upward such that it's right after
ata_pio_task().  This position is more natural and makes adding
prototype for ata_qc_issue_prot() unnecessary.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Implement port_task.  LLDD's can schedule a function to be executed
with context after specified delay.  libata core takes care of
synchronization against EH.  This is generalized form of pio_task and
packet_task which are tied to PIO hsm implementation.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Gaah. Delayed. But all the better for it!

- Don't call eisa_driver_unregister() if eisa_driver_register() failed.

- Properly propagate error values.
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

In latest -mm de620 gave following warning:
WARNING: drivers/net/de620.o - Section mismatch: reference to      \
.init.text:de620_probe from .text between 'init_module' (at offset \
0x1682) and 'cleanup_module'

init_module() call de620_probe() which is declared __init.
Fix is to declare init_module() __init too.
Signed-off-by: NSam Ravnborg <sam@ravnborg.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Improve reference to PCI NE2K support in ISA NE2K documentation.
Original 2.4 patch From: Ged Haywood <ged@jubileegroup.co.uk>
Signed-off-by: NJesper Juhl <jesper.juhl@gmail.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

This patch fixes an error in the dl2k driver's DMA mapping/unmapping.
The adapter uses the upper 16bits of the DMA address for the buffer
size.  However, this is not masked off when referencing the DMA
address, and can lead to errors by trying to free a DMA address out of
range.

Thanks,
Jon
Signed-off-by: NJon Mason <jdmason@us.ibm.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

For some reason, E1000's ->hard_start_xmit() routine returns -EFAULT
instead of one of the NETDEV_TX_* error codes.  In fact, it frees up
the SKB before returning this.  This makes the queueing layer think
the packet should be requeued and subsequently we corrupt a freed
object.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

radeonfb_parse_monitor_layout() will produce an array overrun if passed with a
substring of length higher than 4 (ie, "XXXXX,YYYYYY").

Coverity Bug 494
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Fix static array overrun

Coverity Bug 556
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The pseudo_palette has room only for 16 entries, but tdfxfb_setcolreg may
attempt to write more.

Coverity Bug 557
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The pseudo_palette has room only for 16 entries, but intelfb_setcolreg will
attempt to write more.

Coverity Bug 558
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

par->edid is kfree'd before using in fb_edid_to_monspecs()
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The struct info and device resource may not be released in the driver's error
path.  Fix.

Coverity Bug 671
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

struct info may not be released in the driver's error path.

Coverity Bug 672
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

info->par is dereferenced before info is checked for NULL. Fix.

Coverity Bug 833
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initialize Variable 'count' in DisableVGA to zero.

Coverity Bug 874
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Remove insignificant and uninitialized variable "count" from
arcfb_lcd_update_page.

Coverity Bug 894
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Remove insignificant and unitialized variable "waitcycles" from neo2200_sync.

Coverity Bug 895
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>