Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 29 10月, 2014 17 次提交
  3. 24 10月, 2014 9 次提交
  5. 09 10月, 2014 8 次提交
  7. 08 10月, 2014 6 次提交
    • L
      Fix up missing dmaengine header inclusion from qce crypto engine · f89f4a06
      由 Linus Torvalds 提交于 
      Commit 7bced397 ("net_dma: simple removal") removed the long-dead
net_dma code, but unintentionally broke the build for the qualcomm
crypto engine (qce) that had accidentally depended on the inclusion of
<linux/dmaengine.h> through the networking header files that used to
have it.

Add the required dmaengine.h include explicitly to fix the breakage.
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      f89f4a06
    • T
      ipmi: Clear drvdata when interface is removed · 567eded9
      由 Takao Indoh 提交于 
      This patch fixes a bug on hotmod removing.

After ipmi interface is removed using hotmod, kernel panic occurs when
rmmod impi_si.  For example, try this:

 # echo "remove,"`cat /proc/ipmi/0/params` > \
 /sys/module/ipmi_si/parameters/hotmod
 # rmmod ipmi_si

Then, rmmod fails with the following messages.

  ------------[ cut here ]------------
  WARNING: CPU: 12 PID: 10819 at /mnt/repos/linux/lib/list_debug.c:53 __list_del_entry+0x63/0xd0()
  CPU: 12 PID: 10819 Comm: rmmod Not tainted 3.17.0-rc1 #19
  Hardware name: FUJITSU-SV PRIMERGY BX920 S2/D3030, BIOS 080015 Rev.3D81.3030 02/10/2012
  Call Trace:
    dump_stack+0x45/0x56
    warn_slowpath_common+0x7d/0xa0
    warn_slowpath_fmt+0x4c/0x50
    __list_del_entry+0x63/0xd0
    list_del+0xd/0x30
    cleanup_one_si+0x2a/0x230 [ipmi_si]
    ipmi_pnp_remove+0x15/0x20 [ipmi_si]
    pnp_device_remove+0x24/0x40
    __device_release_driver+0x7f/0xf0
    driver_detach+0xb0/0xc0
    bus_remove_driver+0x55/0xd0
    driver_unregister+0x2c/0x50
    pnp_unregister_driver+0x12/0x20
    cleanup_ipmi_si+0xbc/0xf0 [ipmi_si]
    SyS_delete_module+0x132/0x1c0
    system_call_fastpath+0x16/0x1b
  ---[ end trace 70b4377268f85c23 ]---

list_del in cleanup_one_si() fails because the smi_info is already
removed when hotmod removing.

When ipmi interface is removed by hotmod, smi_info is removed by
cleanup_one_si(), but is is still set in drvdata.  Therefore when rmmod
ipmi_si, ipmi_pnp_remove tries to remove it again and fails.

By this patch, a pointer to smi_info in drvdata is cleared when hotmod
removing so that it will be not accessed when rmmod.

changelog:
v2:
- Clear drvdata in cleanup_one_si
- Change subject

v1:
https://lkml.org/lkml/2014/9/8/741Signed-off-by: NTakao Indoh <indou.takao@jp.fujitsu.com>
Signed-off-by: NCorey Minyard <cminyard@mvista.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      567eded9
    • A
      ipmi: work around gcc-4.9 build warning · cc4cbe90
      由 Arnd Bergmann 提交于 
      Building ipmi on arm with gcc-4.9 results in this warning for an
allmodconfig build:

  drivers/char/ipmi/ipmi_si_intf.c: In function 'ipmi_thread':
  include/linux/time.h:28:5: warning: 'busy_until.tv_sec' may be used uninitialized in this function [-Wmaybe-uninitialized]
    if (lhs->tv_sec > rhs->tv_sec)
       ^
  drivers/char/ipmi/ipmi_si_intf.c:1007:18: note: 'busy_until.tv_sec' was declared here
    struct timespec busy_until;
                    ^

The warning is bogus and this case can not occur.  Apparently this is a
false positive resulting from gcc getting a little smarter about
tracking assignments but not smart enough.

Marking the ipmi_thread_busy_wait function as inline gives the gcc
optimization logic enough information to figure out for itself that the
case cannot happen, which gets rid of the warning without adding any
fake initialization.
Signed-off-by: NArnd Bergmann <arnd@arndb.de>
Signed-off-by: NCorey Minyard <cminyard@mvista.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      cc4cbe90
    • B
      ipmi/of: Don't use unavailable interfaces · 08dc4169
      由 Benjamin Herrenschmidt 提交于 
      If an IPMI controller is used by the firmware and as such marked with
a reserved status, we shouldn't use it.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NCorey Minyard <cminyard@mvista.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      08dc4169
    • C
      ipmi: Clean up the error handling for channel config errors · 1f668423
      由 Corey Minyard 提交于 
      The code to send the channel config errors was missing an error report
in one place and needed some more information in another, and had an
extraneous bit of code.  Clean all that up.
Signed-off-by: NCorey Minyard <cminyard@mvista.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      1f668423
    • E
      net: better IFF_XMIT_DST_RELEASE support · 02875878
      由 Eric Dumazet 提交于 
      Testing xmit_more support with netperf and connected UDP sockets,
I found strange dst refcount false sharing.

Current handling of IFF_XMIT_DST_RELEASE is not optimal.

Dropping dst in validate_xmit_skb() is certainly too late in case
packet was queued by cpu X but dequeued by cpu Y

The logical point to take care of drop/force is in __dev_queue_xmit()
before even taking qdisc lock.

As Julian Anastasov pointed out, need for skb_dst() might come from some
packet schedulers or classifiers.

This patch adds new helper to cleanly express needs of various drivers
or qdiscs/classifiers.

Drivers that need skb_dst() in their ndo_start_xmit() should call
following helper in their setup instead of the prior :

	dev->priv_flags &= ~IFF_XMIT_DST_RELEASE;
->
	netif_keep_dst(dev);

Instead of using a single bit, we use two bits, one being
eventually rebuilt in bonding/team drivers.

The other one, is permanent and blocks IFF_XMIT_DST_RELEASE being
rebuilt in bonding/team. Eventually, we could add something
smarter later.
Signed-off-by: NEric Dumazet <edumazet@google.com>
Cc: Julian Anastasov <ja@ssi.bg>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      02875878