Previously we added i2c buses as needed when enumerating connectors
power management, etc.  This only exposed the actual buses used and
could have lead to the same buse getting created more than once if
one buses was used for more than one purpose.  This patch sets up
all i2c buses on the card in one place and users of the buses just
point back to the one instance.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

- buffer offsets in the base regs are 256b aligned so
shift properly when comparing, fixed by Andre Maasikas
- mipmap size was calculated wrong when nlevel=0
- texture bo offsets were used after the bo base address was added
- vertex resource size register is size - 1, not size
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Cc: Andre Maasikas <amaasikas@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NMarek Olšák <maraeo@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

(For some reason I thought that went in ages ago ...)

This fixes support for PCI domains in what should hopefully be a backward
compatible way along with a change to libdrm.

When the interface version is set to 1.4, we assume userspace understands
domains and the world is at peace. We thus pass proper domain numbers
instead of 0 to userspace.

The newer libdrm will then try 1.4 first, and fallback to 1.1, along with
ignoring domains in the later case (well, except on alpha of course)
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NDave Airlie <airlied@redhat.com>

* 'nouveau/for-airlied' of /ssd/git/drm-nouveau-next: (27 commits)
  drm/nvc0: fix typo in PRAMIN flush
  drm/nouveau: Fix DCB TMDS config parsing.
  drm/nv30: Fix PFB init for nv31.
  drm/nv04: Fix up SGRAM density detection.
  drm/i2c/ch7006: Don't use POWER_LEVEL_FULL_POWER_OFF on early chip versions.
  drm/nouveau: Init dcb->or on cards that have no usable DCB table.
  drm/nouveau: reduce severity of some "error" messages
  drm/nvc0: backup bar3 channel on suspend
  drm/nouveau: implement init table opcodex 0x5e and 0x9a
  drm/nouveau: implement init table op 0x57, INIT_LTIME
  drm/nvc0: implement crtc pll setting
  drm/nvc0: fix evo dma object so we display something
  drm/nvc0: rudimentary instmem support
  drm/nvc0: implement memory detection
  drm/nvc0: allow INIT_GPIO
  drm/nvc0: starting point for GF100 support, everything stubbed
  drm/nv30: Workaround dual TMDS brain damage.
  drm/nouveau: No need to set slave TV encoder configs explicitly.
  drm/nv17-nv4x: Attempt to init some external TMDS transmitters.
  drm/nv10: Fix up switching of NV10TCL_DMA_VTXBUF.
  ...

This hasn't mattered up until the ioctl started using the value, and it fell
apart.

fixes fd.o 29340, Ubuntu LP 606081

[airlied: cleaned up whitespace and don't need an error before pushing]
Signed-off-by: NDr. David Alan Gilbert <linux@treblig.org>
Cc: stable@kernel.org
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Thinko caused by 43bda05428a3d2021f3c12220073e0251c65df8b.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

Fixes a regression introduced by 58bbb63720c8997e0136fe1884101e7ca40d68fd
(fdo bug 29324).
Reported-by: NJohannes Obermayr <johannesobermayr@gmx.de>
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

We need a valid OR value because there're a few nv17 cards with DCB v1.4.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

There's some known configurations where the lack of these tables/scripts
is perfectly normal, reduce visibilty of complaint messages to debug.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
Signed-off-by: NMarcin Kościelnicki <koriakin@0x04.net>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
Signed-off-by: NMarcin Kościelnicki <koriakin@0x04.net>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

sil164 and friends are the most common, usually they just need to be
poked once because a fixed configuration is enough for any modes and
clocks, so they worked without this patch if the BIOS had done a good
job on POST. Display couldn't survive a suspend/resume cycle though.
Unfortunately, BIOS scripts are useless here.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Not very nice, but I don't think there's a simpler workaround.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Leaving the IRQ unack'ed while switching contexts makes the switch
fail randomly on some nv1x.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

nouveau_load() just returned directly if there was an error instead of
releasing resources.
Signed-off-by: NDan Carpenter <error27@gmail.com>
Reviewed-by: NMarcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Previously nouveau_mem_reset_agp() was only disabling AGP fast writes
when coming back from suspend. However, the "locked out of the card
because of FW" problem can also be reproduced on init if you
unload/reload nouveau.ko several times. This patch makes the AGP code
reset FW on init.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This makes it easier to see how this is working, and lets us transfer the
EDID in blocks of 16 bytes.

The primary reason for this change is because debug logs are rather hard
to read with the hundreds of single-byte auxch transactions that occur.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

IRQ and resource[] may not have correct values until
after PCI hotplug setup occurs at pci_enable_device() time.

The semantic match that finds this problem is as follows:

// <smpl>
@@
identifier x;
identifier request ~= "pci_request.*|pci_resource.*";
@@

(
* x->irq
|
* x->resource
|
* request(x, ...)
)
 ...
*pci_enable_device(x)
// </smpl>
Signed-off-by: NKulikov Vasiliy <segooon@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

IRQ and resource[] may not have correct values until
after PCI hotplug setup occurs at pci_enable_device() time.

The semantic match that finds this problem is as follows:

// <smpl>
@@
identifier x;
identifier request ~= "pci_request.*|pci_resource.*";
@@

(
* x->irq
|
* x->resource
|
* request(x, ...)
)
 ...
*pci_enable_device(x)
// </smpl>
Signed-off-by: NKulikov Vasiliy <segooon@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This restricts the use of the big kernel lock to the i830 and i810
device drivers. The three remaining users in common code (open, ioctl
and release) get converted to a new mutex, the drm_global_mutex,
making the locking stricter than the big kernel lock.

This may have a performance impact, but only in those cases that
currently don't use DRM_UNLOCKED flag in the ioctl list and would
benefit from that anyway.

The reason why i810 and i830 cannot use drm_global_mutex in their
mmap functions is a lock-order inversion problem between the current
use of the BKL and mmap_sem in these drivers. Since the BKL has
release-on-sleep semantics, it's harmless but it would cause trouble
if we replace the BKL with a mutex.

Instead, these drivers get their own ioctl wrappers that take the
BKL around every ioctl call and then set their own handlers as
DRM_UNLOCKED.
Signed-off-by: NArnd Bergmann <arnd@arndb.de>
Cc: David Airlie <airlied@linux.ie>
Cc: dri-devel@lists.freedesktop.org
Signed-off-by: NDave Airlie <airlied@redhat.com>

In most use cases the driver will be using the same static config all
the time: interpreting i2c_board_info::platform_data as the default
config we can can save the GPU driver a redundant set_config() call.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This is required should we ever attempt to use an io-mapping where
KM_USER0 is verboten, such as inside an IRQ context.
Signed-off-by: NChris Wilson <chris@chris-wilson.co.uk>
Cc: Eric Anholt <eric@anholt.net>
Signed-off-by: NDave Airlie <airlied@redhat.com>

R4xx also uses the atom add connector function, but underscan is only
supported on avivo chips.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

New evergreen and r7xx ids.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Cc: stable@kernel.org
Signed-off-by: NDave Airlie <airlied@redhat.com>