- 12 12月, 2007 1 次提交
-
-
由 Kumar Gala 提交于
* Removed device_type = "i2c" * Added missing second I2C controller on MPC8548 CDS, MPC8544 DS * Added #address-cells, #size-cells, and cell-index where missing Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 14 9月, 2007 3 次提交
-
-
由 Anton Vorontsov 提交于
Enabled using SPI controller on the MPC832x RDB board. We currently use a modalias of "spidev" as a place holder (replace with "mmc_spie") until the mmc_spi driver support is merged in. This gets us the ability to test SPI until then. Signed-off-by: NAnton Vorontsov <avorontsov@ru.mvista.com> Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
由 Kumar Gala 提交于
Updated the device trees to have the PCI nodes be at the same level as the SOC node. This is to make it so that the SOC nodes children address space is just on chip registers and not other bus memory as well. Also, for PCIe nodes added a P2P bridge to handle the virtual P2P bridge that exists in the PHB. Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
由 Kumar Gala 提交于
Removed the following cruft from .dts files: * 32-bit in cpu node -- doesn't exist in any spec and not used by kernel * removed built-in (chrp legacy) * Removed #interrupt-cells in places they don't need to be set * Fixed ranges on lite5200* * Removed clock-frequency from i8259 pic node, not sure where this came from * Removed big-endian from i8259 pic nodes, this was just bogus Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 23 7月, 2007 1 次提交
-
-
由 Roy Zang 提交于
Updated the 83xx & 85xx device tree PCI related compartible property. Used the following compatible properties: PCI "fsl,mpc8349-pci" PCI "fsl,mpc8540-pci" PCI-X: "fsl,mpc8540-pcix" PCIe: "fsl,mpc8548-pcie" Signed-off-by: NRoy Zang <tie-fei.zang@freescale.com> Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 03 7月, 2007 1 次提交
-
-
由 Timur Tabi 提交于
For the 83xx, 85xx, and 86xx device trees, add a "local-mac-address" property to every Ethernet node that didn't have one. Add a comment indicating that the "address" and/or "mac-address" properties are deprecated in DTS files and will be removed at a later time. Change all MAC address properties to have a zero MAC address value. Signed-off-by: NTimur Tabi <timur@freescale.com> Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 02 5月, 2007 1 次提交
-
-
由 Kim Phillips 提交于
phy-connection-type now supersedes the interface property. Signed-off-by: NKim Phillips <kim.phillips@freescale.com> Signed-off-by: NPaul Mackerras <paulus@samba.org>
-
- 30 3月, 2007 1 次提交
-
-
由 Michael Barkowski 提交于
Add support for the MPC8323E Reference Development Board (RDB). The board is a mini-ITX reference board with 64M DDR2, 16M flash, USB, PCI, 10/100 ethernet, serial, and phone ports. Signed-off-by: NMichael Barkowski <michael.barkowski@freescale.com> Signed-off-by: NKim Phillips <kim.phillips@freescale.com> Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 09 3月, 2007 1 次提交
-
-
由 Stuart Yoder 提交于
The #cpus property is unused and undocumented and is therefore being removed. Signed-off-by: NStuart Yoder <stuart.yoder@freescale.com> Acked-by: NDavid Gibson <david@gibson.dropbear.id.au> Signed-off-by: NPaul Mackerras <paulus@samba.org>
-
- 18 2月, 2007 1 次提交
-
-
由 Kumar Gala 提交于
Renamed the MPC8323 MDS and defconfig to match the naming convention followed by other MDS boards. Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 17 2月, 2007 1 次提交
-
-
由 Kumar Gala 提交于
* Fixed up top level compatible property for all boards * Removed explicit linux,phandle usage. Use references and labels now * Fixed interrupt sense attribute, some interrupts were marked edge, that are level Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 16 2月, 2007 1 次提交
-
-
由 Timur Tabi 提交于
The 'linux,boot-cpu' property is obsolete, so remove it from all of the DTS files and from booting-without-of.txt. The boot CPU is actually defined in the device tree header, and U-Boot sets that field. The device tree compiler also complains if the property exists. Signed-off-by: NTimur Tabi <timur@freescale.com> Signed-off-by: NStuart Yoder <stuart.yoder@freescale.com> Acked-by: NDavid Gibson <dwg@au1.ibm.com> Signed-off-by: NPaul Mackerras <paulus@samba.org>
-
- 31 1月, 2007 1 次提交
-
-
由 Kim Phillips 提交于
Add the mpc8323emds device tree source (dts) Signed-off-by: NScott Wood <scottwood@freescale.com> Signed-off-by: NKim Phillips <kim.phillips@freescale.com> Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
- 04 10月, 2006 1 次提交
-
-
由 Li Yang 提交于
Add MPC8360EMDS default device-tree source file Signed-off-by: NLi Yang <leoli@freescale.com> Signed-off-by: NJiang Bo <Tanya.jiang@freescale.com> Signed-off-by: NKim Phillips <kim.phillips@freescale.com> Signed-off-by: NPaul Mackerras <paulus@samba.org>
-