It is a good tone to reset driver data after unbinding the device.
Also set up drivers owner.
Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
Acked-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>

ret should be signed to notice a failure in wm831x_reg_read().
Signed-off-by: NRoel Kluin <roel.kluin@gmail.com>
Acked-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>

If ret is unsigned, the checks for negative wm831x_reg_read() return values
are wrong. The error value should be transmitted to its caller, e.g.
wm831x_gp_ldo_get_status() which tests for a negative return value.
Signed-off-by: NRoel Kluin <roel.kluin@gmail.com>
Acked-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>

The WM831x series of devices provide three types of LDO:

 - General purpose LDOs supporting voltages from 0.9-3.3V
 - High performance analogue LDOs supporting voltages from 1-3.5V
 - Very low power consumption LDOs intended to support always on
   functionality.

This patch adds support for all three kinds of LDO. Each regulator
is probed as an individual platform device with resources used to
provide the register map location of the regulator. Mixed hardware
and software control of regulators is not current supported.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: NLiam Girdwood <lrg@slimlogic.co.uk>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>