Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 25 9月, 2014 7 次提交
    • N
      NFS: don't use STABLE writes during writeback. · e87b4c7a
      由 NeilBrown 提交于 
      commit b31268ac
  FS: Use stable writes when not doing a bulk flush

was a bit heavy handed.
The particular problem that lead to this patch was that
small writes to an O_SYNC file we being written as UNSTABLE writes
followed by a commit.
This is appropriate for large writes (which require multiple NFS
requests) but for small writes (single NFS request), using
NFS_FILE_SYNC is more efficient.

So that patch causes the code to select between the two methods
depending on how many nfs requests get generated.

Unfortunately this ends up applying to non O_SYNC writes as well.
In particular if you memory-map a file and update random pages, then
when they are eventually written out by writeback they will go as
NFS_FILE_SYNC.  This is inefficient and slows down the application.

So: only set FLUSH_COND_STABLE when wbc->sync_mode is WB_SYNC_ALL.
With this patch:
 O_SYNC writes are NFS_FILE_SYNC for single requests, and NFS_UNSTABLE
    followed by COMMIT for multiple requests
 Writing immediately before close of fsync follow the same pattern.
 Non-O_SYNC writes without an fsync of close eventually get flushed
 out as UNSTABLE and a commit follows eventually as appropriate.
Signed-off-by: NNeilBrown <neilb@suse.de>
Signed-off-by: NTrond Myklebust <trond.myklebust@primarydata.com>
      e87b4c7a
    • N
      NFSv4: use exponential retry on NFS4ERR_DELAY for async requests. · 8478eaa1
      由 NeilBrown 提交于 
      Currently asynchronous NFSv4 request will be retried with
exponential timeout (from 1/10 to 15 seconds), but async
requests will always use a 15second retry.

Some "async" requests are really synchronous though.  The
async mechanism is used to allow the request to continue if
the requesting process is killed.
In those cases, an exponential retry is appropriate.

For example, if two different clients both open a file and
get a READ delegation, and one client then unlinks the file
(while still holding an open file descriptor), that unlink
will used the "silly-rename" handling which is async.
The first rename will result in NFS4ERR_DELAY while the
delegation is reclaimed from the other client.  The rename
will not be retried for 15 seconds, causing an unlink to take
15 seconds rather than 100msec.

This patch only added exponential timeout for async unlink and
async rename.  Other async calls, such as 'close' are sometimes
waited for so they might benefit from exponential timeout too.
Signed-off-by: NNeilBrown <neilb@suse.de>
Signed-off-by: NTrond Myklebust <trond.myklebust@primarydata.com>
      8478eaa1
    • J
      rpc: Add -EPERM processing for xs_udp_send_request() · 3dedbb5c
      由 Jason Baron 提交于 
      If an iptables drop rule is added for an nfs server, the client can end up in
a softlockup. Because of the way that xs_sendpages() is structured, the -EPERM
is ignored since the prior bits of the packet may have been successfully queued
and thus xs_sendpages() returns a non-zero value. Then, xs_udp_send_request()
thinks that because some bits were queued it should return -EAGAIN. We then try
the request again and again, resulting in cpu spinning. Reproducer:

1) open a file on the nfs server '/nfs/foo' (mounted using udp)
2) iptables -A OUTPUT -d <nfs server ip> -j DROP
3) write to /nfs/foo
4) close /nfs/foo
5) iptables -D OUTPUT -d <nfs server ip> -j DROP

The softlockup occurs in step 4 above.

The previous patch, allows xs_sendpages() to return both a sent count and
any error values that may have occurred. Thus, if we get an -EPERM, return
that to the higher level code.

With this patch in place we can successfully abort the above sequence and
avoid the softlockup.

I also tried the above test case on an nfs mount on tcp and although the system
does not softlockup, I still ended up with the 'hung_task' firing after 120
seconds, due to the i/o being stuck. The tcp case appears a bit harder to fix,
since -EPERM appears to get ignored much lower down in the stack and does not
propogate up to xs_sendpages(). This case is not quite as insidious as the
softlockup and it is not addressed here.
Reported-by: NYigong Lou <ylou@akamai.com>
Signed-off-by: NJason Baron <jbaron@akamai.com>
Signed-off-by: NTrond Myklebust <trond.myklebust@primarydata.com>
      3dedbb5c
    • J
      rpc: return sent and err from xs_sendpages() · f279cd00
      由 Jason Baron 提交于 
      If an error is returned after the first bits of a packet have already been
successfully queued, xs_sendpages() will return a positive 'int' value
indicating success. Callers seem to treat this as -EAGAIN.

However, there are cases where its not a question of waiting for the write
queue to drain. For example, when there is an iptables rule dropping packets
to the destination, the lower level code can return -EPERM only after parts
of the packet have been successfully queued. In this case, we can end up
continuously retrying resulting in a kernel softlockup.

This patch is intended to make no changes in behavior but is in preparation for
subsequent patches that can make decisions based on both on the number of bytes
sent by xs_sendpages() and any errors that may have be returned.
Signed-off-by: NJason Baron <jbaron@akamai.com>
Signed-off-by: NTrond Myklebust <trond.myklebust@primarydata.com>
      f279cd00
    • B
      lockd: Try to reconnect if statd has moved · 173b3afc
      由 Benjamin Coddington 提交于 
      If rpc.statd is restarted, upcalls to monitor hosts can fail with
ECONNREFUSED.  In that case force a lookup of statd's new port and retry the
upcall.
Signed-off-by: NBenjamin Coddington <bcodding@redhat.com>
Cc: stable@vger.kernel.org
Signed-off-by: NTrond Myklebust <trond.myklebust@primarydata.com>
      173b3afc
    • B
      SUNRPC: Don't wake tasks during connection abort · a743419f
      由 Benjamin Coddington 提交于 
      When aborting a connection to preserve source ports, don't wake the task in
xs_error_report.  This allows tasks with RPC_TASK_SOFTCONN to succeed if the
connection needs to be re-established since it preserves the task's status
instead of setting it to the status of the aborting kernel_connect().

This may also avoid a potential conflict on the socket's lock.
Signed-off-by: NBenjamin Coddington <bcodding@redhat.com>
Cc: stable@vger.kernel.org # 3.14+
Signed-off-by: NTrond Myklebust <trond.myklebust@primarydata.com>
      a743419f
    • O
      Fixing lease renewal · 8faaa6d5
      由 Olga Kornievskaia 提交于 
      Commit c9fdeb28 removed a 'continue' after checking if the lease needs
to be renewed. However, if client hasn't moved, the code falls down to
starting reboot recovery erroneously (ie., sends open reclaim and gets
back stale_clientid error) before recovering from getting stale_clientid
on the renew operation.
Signed-off-by: NOlga Kornievskaia <kolga@netapp.com>
Fixes: c9fdeb28 (NFS: Add basic migration support to state manager thread)
Cc: stable@vger.kernel.org # 3.13+
Signed-off-by: NTrond Myklebust <trond.myklebust@primarydata.com>
      8faaa6d5
  3. 22 9月, 2014 1 次提交
  5. 16 9月, 2014 1 次提交
  7. 13 9月, 2014 15 次提交
  9. 11 9月, 2014 16 次提交