- Removed some kmalloc's with __GFP_ZERO and replace it with memset()
  because it didn't work properly.

- Fixed returned message frame in i2o_cfg_passthru() which caused raidutils
  to display wrong error message in case a disk was missing.

- Fixed size of printk() in i2o_scsi.c.

- Fixed get_device() and put_device() in probing of the I2O controller.
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Changed the I2O API to create I2O messages first in kernel memory and then
transfer it at once over the PCI bus instead of sending each quad-word over
the PCI bus.
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

When dpt_i2o is loaded first, i2o being loaded would cause it to call
pci_device_disable, thus breaking dpt_i2o's use of the device.  Based on
similar usage of pci_disable_device in other drivers.
Signed-off-by: NBen Collins <bcollins@ubuntu.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The Coverity checker spotted this obvious NULL pointer dereference.
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Acked-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Added pci_request_regions() before using the controller to avoid duplicate
usage of the I2O controller when the dpt_i2o driver and I2O subsystem is
loaded at the same time.
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Cc: James Bottomley <James.Bottomley@SteelEye.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Set max sectors to 256 for Promise controllers.
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Lindent run and replaced printk() through the corresponding osm_*() function
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Changes:
 - Added header "core.h" for i2o_core.ko internal definitions
 - More sparse fixes
 - Changed display of TID's in sysfs attributes from XXX to 0xXXX
 - Use the right functions for accessing I/O and normal memory
 - Removed error handling of SCSI device errors and let the SCSI layer
   take care of it
 - Added new device / removed device handling to SCSI-OSM
 - Make status access volatile
 - Cleaned up activation of I2O controller
 - Removed unnecessary wmb() and rmb() calls
 - Use own struct i2o_io for I/O memory instead of struct i2o_dma
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Changes:
 - Provide SG_IO access to BLOCK and EXECUTIVE class on Adaptec
   controllers
 - Use PRIVATE messages in SCSI-OSM because on some controllers normal
   SCSI class commands like READ or READ CAPACITY cause errors
 - Use new DMA and SG list creation function
 - Added workaround to limit sectors per request for Adaptec 2400A
   controllers
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Changes:
 - Added Bus-OSM which could be used by user space programs to reset a
   channel on the controller
 - Make ioctl's in Config-OSM obsolete in prefer for sysfs attributes and
   move those to its own file
 - Added sysfs attribute for firmware read and write access for I2O
   controllers
 - Added special handling of firmware read and write access for Adaptec
   controllers
 - Added vendor id and product id as sysfs-attribute to Executive classes
 - Added automatic notification of LCT change handling to Exec-OSM
 - Added flushing function to Block-OSM for later barrier implementation
 - Use PRIVATE messages for Block access on Adaptec controllers, which are
   faster then BLOCK class access
 - Cleaned up support for Promise controller
 - New messages are now detected using the IRQ status register as
   suggested by the I2O spec
 - Added i2o_dma_high() and i2o_dma_low() functions
 - Added facility for SG tablesize calculation when using 32-bit and
   64-bit DMA addresses
 - Added i2o_dma_map_single() and i2o_dma_map_sg() which could build the
   SG list for 32-bit as well as 64-bit DMA addresses
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Changes:

 - Removed unnecessary checking of NULL before calling kfree()
 - Make some functions static
 - Changed pr_debug() into osm_debug()
 - Use i2o_msg_in_to_virt() for getting a pointer to the message frame
 - Cleaned up some comments
 - Changed some le32_to_cpu() into readl() where necessary
 - Make error messages of OSM's look the same
 - Cleaned up error handling in i2o_block_end_request()
 - Removed unused error handling of failed messages in Block-OSM, which
   are not allowed by the I2O spec
 - Corrected the blocksize detection in i2o_block
 - Added hrt and lct sysfs-attribute to controller
 - Call done() function in SCSI-OSM after freeing DMA buffers
 - Removed unneeded variable for message size calculation in
   i2o_scsi_queuecommand()
 - Make some changes to remove sparse warnings
 - Reordered some functions
 - Cleaned up controller initialization
 - Replaced some magic numbers by defines
 - Removed unnecessary dma_sync_single_for_cpu() call on coherent DMA
 - Removed some unused fields in i2o_controller and removed some unused
   functions
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Changes:

 - Fixed sysfs bug where user and parent links where added to the I2O
   device itself
 - Fixed bug when calculating TID for the event handler and cleaned up the
   workflow of i2o_driver_dispatch()
 - Fixed oops when no I2O device could be found for an event delivered to
   Exec-OSM
 - Fixed initialization of spinlock in Exec-OSM
 - Fixed memory leak in i2o_cfg_passthru() and i2o_cfg_passthru()
 - Removed MTRR support
 - Added PCI ID of Promise SX6000 with firmware >= 1.20.x.x
 - Turn of caching for ioremapped memory of in_queue
 - Added initialization sequence for Promise controllers
 - Moved definition of u8 / u16 / u32 for raidutils before first use
Signed-off-by: NMarkus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!