Revert the dynarray changes. They need more thought and polishing.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Remove the leftover of sparseirqs.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

This code is not ready, but we need to rip it out instead of rebasing
as we would lose the APIC/IO_APIC unification otherwise.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

For the non sparse irq case an inline function is perfectly fine.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Move all of those to linux/irq.h where they belong.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Revert the sparse irq changes in m68k/s390/sparc and just define
nr_irqs as NR_IRQS for those architectures.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Create /sys/firmware/sgi_uv sysfs entries for partition_id and coherence_id.
Signed-off-by: NRuss Anderson <rja@sgi.com>
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Add a bios call to return partitioning related info.
Signed-off-by: NRuss Anderson <rja@sgi.com>
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Add the EFI callback function and associated wrapper code.
Initialize SAL system table entry info at boot time.
Signed-off-by: NRuss Anderson <rja@sgi.com>
Signed-off-by: NPaul Jackson <pj@sgi.com>
Acked-by: NHuang Ying <ying.huang@intel.com>
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Look for a UV entry in the EFI tables.
Signed-off-by: NRuss Anderson <rja@sgi.com>
Signed-off-by: NPaul Jackson <pj@sgi.com>
Acked-by: NHuang Ying <ying.huang@intel.com>
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Provide a means for UV interrupt MMRs to be setup with the message to be sent
when an MSI is raised.
Signed-off-by: NDean Nelson <dcn@sgi.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Basic HPET MSI setup code. Routines to perform basic MSI read write
in HPET memory map and setting up irq_chip for HPET MSI.
Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com>
Signed-off-by: NShaohua Li <shaohua.li@intel.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Very early detection of the DMAR tables will setup fixmap mapping. For
parsing these tables later (while enabling dma and/or interrupt remapping),
early fixmap mapping shouldn't be used. Fix it by calling table detection
routines again, which will call generic apci_get_table() for setting up
the correct mapping.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

APIC_ARBPRI is a reserved register for XAPIC and beyond.
APIC_RRR is a reserved register except for 82489DX, APIC for Pentium processors.
APIC_EOI is a write only register.
APIC_DFR is reserved in x2apic mode.

Access to these registers in x2apic will result in #GP fault. Fix these
apic register accesses.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com>
Cc: Maciej W. Rozycki <macro@linux-mips.org>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

According to entry_64.S we do pass pt_regs pointer
into interrupt handlers but don't use them. So we
safely may merge the declarations.
Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

fix non-sparseirq architectures.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

for !CONFIG_HAVE_SPARSE_IRQ

fix:

 In file included from arch/x86/kernel/early-quirks.c:18:
 include/asm/io_apic.h: In function 'probe_nr_irqs':
 include/asm/io_apic.h:209: error: 'NR_IRQS' undeclared (first use in this function)
 include/asm/io_apic.h:209: error: (Each undeclared identifier is reported only once
 include/asm/io_apic.h:209: error: for each function it appears in.)

v2: fix by Ingo
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

no user now
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

we are using 28bit pci (bus/dev/fn + 12 bits) as irq number, so the
cache for irq number should be 32 bit too.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

no user left.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

let user decide the meaning of the bits.

This unifies the 32-bit and 64-bit io-apic code a bit.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

so we can merge io_apic_32.c and io_apic_64.c

v2: Use cpu_online_map as target cpus for bigsmp, just like 64-bit is doing.

Also remove some unused TARGET_CPUS macro.

v3: need to check if desc is null in smp_irq_move_cleanup

also migration needs to reset vector too, so copy __target_IO_APIC_irq
from 64bit.

(the duplication will go away once the two files are unified.)
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

This has been deprecated for years, the user space irqbalanced utility
works better with numa, has configurable policies, etc...
Signed-off-by: NYinghai Lu <yhlu.kernel@gmai.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

also print out irq no in /proc/interrups and /proc/stat in hex, so could
tell bus/dev/func.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

when CONFIG_HAVE_SPARSE_IRQ
preallocate some irq_2_iommu entries, and use get_one_free_irq_2_iomm to
get new one and link to irq_desc if needed.

else will use dyn_array or static array.

v2: <= nr_irqs fix
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

so later don't need compare with -1U
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

change names:

          irq_desc() ==> irq_desc_alloc
	__irq_desc() ==> irq_desc

Also split a few of the uses in lowlevel x86 code.

v2: need to check if desc is null in smp_irq_move_cleanup
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

So we could remove some duplicated calling to irq_desc

v2: make sure irq_desc in  init/main.c is not used without generic_hardirqs
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Replace another nr_irqs loop to avoid the allocation of all sparse
irq entries - use for_each_irq_desc instead.

v2: make sure arch without GENERIC_HARDIRQS works too
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

There are a handful of loops that go from 0 to nr_irqs and use
get_irq_desc() on them. These would allocate all the irq_desc
entries, regardless of the need for them.

Use the smarter for_each_irq_desc() iterator that will only iterate
over the present ones.

v2: make sure arch without GENERIC_HARDIRQS work too
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

add an irq_desc accessor that will not allocate any sparse entry
but returns failure if there's no entry present.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

based on Eric's patch ...

together mold it with dyn_array for irq_desc, will allcate kstat_irqs for
nr_irq_desc alltogether if needed. -- at that point nr_cpus is known already.

v2: make sure system without generic_hardirqs works they don't have irq_desc
v3: fix merging
v4: [mingo@elte.hu] fix typo

[ mingo@elte.hu ] irq: build fix

fix:

 arch/x86/xen/spinlock.c: In function 'xen_spin_lock_slow':
 arch/x86/xen/spinlock.c:90: error: 'struct kernel_stat' has no member named 'irqs'
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

irq_timer_state[] is a NR_IRQS sized array that is a side-by array to
the real irq_desc[] array.

Integrate that field into the (now dynamic) irq_desc dynamic array and
save some RAM.

v2: keep the old way to support arch not support irq_desc
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

add CONFIG_HAVE_SPARSE_IRQ to for use condensed array.
Get rid of irq_desc[] array assumptions.

Preallocate 32 irq_desc, and irq_desc() will try to get more.

( No change in functionality is expected anywhere, except the odd build
  failure where we missed a code site or where a crossing commit itroduces
  new irq_desc[] usage. )

v2: according to Eric, change get_irq_desc() to irq_desc()
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

remove unused defines derived from the (now obsolete) NR_IRQS define.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Until now, NR_IRQS was derived from black magic defines that had to
be "large enough" to both accomodate NR_CPUS and MAX_NR_IO_APICs.

This resulted in a way too large irq_desc[] array on most x86 systems.
Especially with larger CPU masks, the size of irq_desc can spiral out
of control quickly.

So be smarter about it and use precise allocation instead: determine the
default maximum possible IRQ number from the ACPI MADT. Use a minimum limit
of at least 32 IRQs for broken BIOSes.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

also add first_free_entry and pin_map_size, which were NR_IRQS derived
constants.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>