For a normal suspend/resume we allready wait for
the rings to be empty, and for a suspend/reasume
in case of a lockup we REALLY don't want to wait
for anything.
Signed-off-by: NChristian König <deathsimple@vodafone.de>
Reviewed-by: NJerome Glisse <jglisse@redhat.com>
Reviewed-by: NAlex Deucher <alexander.deucher@amd.com>

So we can skip the locking. Also renames sw_int to
ring_int, cause that better matches its purpose.
Signed-off-by: NChristian Koenig <christian.koenig@amd.com>

1. It is really dangerous to have more than one
   spinlock protecting the same information.

2. radeon_irq_set sometimes wasn't called with lock
   protection, so it can happen that more than one
   CPU would tamper with the irq regs at the same
   time.

3. The pm.gui_idle variable was assuming that the 3D
   engine wasn't becoming idle between testing the
   register and setting the variable. So just remove
   it and test the register directly.

v2: Also handle the hpd irq code the same way.
v3: Rename hpd parameter for clarification.
Signed-off-by: NChristian Koenig <christian.koenig@amd.com>
Reviewed-by: NAlex Deucher <alexander.deucher@amd.com>

The spinlock was actually there to protect the
rptr, but rptr was read outside of the locked area.

Also we don't really need a spinlock here, an
atomic should to quite fine since we only need to
prevent it from being reentrant.

v2: Keep the spinlock....
v3: Back to an atomic again after finding & fixing the real bug.
Signed-off-by: NChristian Koenig <christian.koenig@amd.com>

It is completely unnecessary to create fences
before they are emitted, so remove it and a bunch
of checks if fences are emitted or not.
Signed-off-by: NChristian König <deathsimple@vodafone.de>
Reviewed-by: NJerome Glisse <jglisse@redhat.com>

- Properly set up the RBs
- Properly set up the SPI
- Properly set up gb_addr_config

This should fix rendering issues on certain cards.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This adds prime->fd and fd->prime support to radeon.
It passes the sg object to ttm and then populates
the gart entries using it.

Compile tested only.

v2: stub kmap + use new helpers + add reimporting
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Reviewed-by: NJerome Glisse <jglisse@redhat.com>
Reviewed-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

All radeon_gem_init() does is initialize the gem objects
list.  radeon_device.c does this explicitly.  r600+ calls
radeon_gem_init() so the list gets initialized twice.  Older
asics don't call it at all and rely on the the init in
radeon_device.c.  Just call radeon_gem_init() in radeon_device.c
and remove the explicit calls from all the newer asics.

All asics call radeon_gem_fini() in their fini pathes.  That
could possibly be cleaned up too.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Reviewed-by: NMichel Dänzer <michel.daenzer@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Without this, e.g. egltri_screen looks scrambled after a GPU reset.
Signed-off-by: NMichel Dänzer <michel.daenzer@amd.com>
Reviewed-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Directly use the suballocator to get small chunks of memory.
It's equally fast and doesn't crash when we encounter a GPU reset.

v2: rebased on new SA interface.
Signed-off-by: NChristian König <deathsimple@vodafone.de>
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Nothing chipset or ring specific with it,
so also move it to radon_ring.
Signed-off-by: NChristian König <deathsimple@vodafone.de>
Reviewed-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

It isn't chipset specific, so it makes no sense
to have that inside r100.c.
Signed-off-by: NChristian König <deathsimple@vodafone.de>
Reviewed-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Forget to unreserve after pinning.  This can lead to problems in
soft reset and resume.

v2: rework patch as per Michel's suggestion.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Reviewed-by: NMichel Dänzer <michel.daenzer@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This closes a race seen with kexec where we enable PCI bus mastering
but the card has been reinitialised fully yet.

This was previously fixed by a patch from Jerome, but this should
close the race completely.

v2: add SI support as suggested by Alex.
Reported-and-tested-by: NMarkus Trippelsdorf <markus@trippelsdorf.de>
Signed-off-by: NDave Airlie <airlied@redhat.com>

v2: fix check for MC ucode from Tom.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This is mostly identical to evergreen/ni, however
there are some additional fields in the IV vector
for RINGID and VMID.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

RLC handles the interrupt controller and other tasks
on the GPU.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Support both IBs (DE) and CONST IBs (CE).
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Currently the driver required 5 sets of ucode:
1. pfp - pre-fetch parser, part of the CP
2. me - micro engine, part of the CP
3. ce - constant engine, part of the CP
4. rlc - interrupt controller
5. mc - memory controller
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Sets up the VM and adds support for the new VM ioctls.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>